User Manual
Ultrasonic Humidifier · Model No. VS 100
Important! Read and Save These Instructions.
Read all instructions:
Important Safeguards
When using electrical appliances, especially when children are present, basic safety
precautions should always be followed, including the following:
1. Always have water in the water tank when operating unit.
2. Use only clean, cool tap water to fill tank.
3. Use only 110-120V AC outlet. As with any electrical device, plug and unplug unit
with dry hands only. Turn unit off prior to unplugging it. Unplug unit when not in use
and before you clean or move the unit.
4. This unit shuts off automatically when water tank is empty.
5. Never operate unit with a damaged cord or plug. Keep cord straight.
6. Always place unit on a flat, level surface away from direct sunlight. Keep cord away
from heated surfaces and areas where it could be walked on or tripped over.
7. Do not add medication, fragrances, or oils of any type into the nozzle, base or water
tank. Do not cover the nozzle of the unit or insert objects into any openings.
8. The unit should not be left unattended in closed rooms as air could become saturated
and leave condensation on walls or furniture. Always leave room door partially open.
9. Do not tilt or tip unit or attempt to empty or fill it while it is operating.
10. Replace demineralization cartridge every 2-3 months.
Parts Descriptions
Vapor nozzle
Water level sensor
Oscillator
Base
Handle
Tank
Internal ventilator
Cleaning brush.
Used for cleaning of Oscillator and internal parts.
Control panel
Power cord
2
Power light
Power on: green
Warm mist: red
no water: light “off “
Humidity
controller
sets desired
humidity
cold/warm mist
selector switch
Features
• Ultra-quiet operation.
• Optional cool or warm mist operation.
• Built-in hygrostat for controlled humidification.
How To Use Your Venta-Sonic™ Humidifier
Important!
Place unit on a level surface away from direct sunlight. Keep cord away from heated
surfaces and areas where it could be walked on or tripped over.
Fill Water Tank.
Turn off humidifier and unplug unit. Remove tank from base. Turn upside down and
unscrew filling cap. Fill tank with clean, cool, distilled, filtered or tap water. Water
temperature should NEVER be too hot or too cold. Extreme temperatures can damage
unit. Tighten filling cap firmly. Return tank to base and let sit for a few minutes.
Power/
Spray controller
Turn Unit On.
Plug power cord into a 110-120V AC wall outlet only. Turn power switch (POWER/SPRAY)
on (turn clockwise). Power light will illuminate. A green light indicates “cold mist” operation
and a “red” light indicates “warm mist” operation. You may change from cold mist to
warm mist and vice versa by pressing the selector switch (WARM MIST) in the bottom
center of the control panel. Aim nozzle away from furniture and walls. Mist may take up
to 40 seconds to be visible.
Turn Unit Off When Finished.
Always turn humidifier off and unplug unit when not in use.
3