ZORNBM-3 / 7847C-NBM3
Infor mation to User
Information to the User
The NBM-3 Bl u etoot h M od u le is intended for integration into Novero products only. Therefore
it has no User Manual. The following information will be included in the end product User
Guide:
FCC/Industry Canada notice
This device complies with Part 15 of the FCC and Industry Canada Rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference; and
2. This device must accept any interference received, including interference that may cause
undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
FCC Radiation Exposure Statement
This equipment complies with FCC and Industry Canada radiation exposure limits set forth
for an uncontrolled environment. End user s m ust follow the specific operating instructions
for satisfying exposure compliance. This transmitter must not be co-located or operating in
conjunction with any other antenna or tran smitter.
NOTE: Changes or modifications not expressly approved by Novero could void the user’s
authority to operate the equipment.
Label Information FCC/Industry Canada:
If the module is installed inside host dev ices, then the outside of the device into which the
module is inst alled must display a label referring to the enclosed module. This exterior label
shall use wording such as the following:
Contains FCC ID: ZORNBM-3
IC: 7847C-NBM3
Copyright 2011 novero. All rights reserved.
Loading...