NovaStar PBOX150 Quick Start Manual

All intellectual property rights involved in this document belong to

Xi’an NovaStar Tech Co., Ltd. All rights are reserved.

PBOX150 Quick Start Guide

Stable, Reliable and Powerful

Rev1.0.0 NS120100105

XI'AN NOVASTAR TECH CO., LTD

- 1-

PBOX150 Features

1) With synchronous and asynchronous dual-mode and

supports full zoom of video input in synchronous mode;

2) Supports HDMI Loop;

3) Supports WiFi function to enable wireless

communication;

4) WiFi function supports AP+Sta at the same time and you

can build your LAN while connecting public network;

5) Supports a load capability of 600,000 pixels and

maximum width up to 2048 pixels and maximum height

up to 1024 pixels;

6) Supports redundancy backup of Gigabit Ethernet port;

7) Supports audio output with stereo dual-channel;

8) One-click to switch between synchronous and

asynchronous mode, including the switch of both audio

and video;

9) Supports USB playing and playing programs imported

from USB drives ;

10) Supports three modes of brightness adjustment: timing,

automatic and manual adjustment;

11) Supports screen locking and blackout;

12) Supports screen on/off via power switch;

XI'AN NOVASTAR TECH CO., LTD

- 2-

13) Supports SD card memory expansion;

14) Supports remote cluster control and play over the

Internet;

15) Supports various media formats such as video, picture,

text, weather, clock, countdown, Flash(Versions higher

than V7.0 are not supported for the moment.), Word,
Excel, Txt…;

16) Supported chips: a full range of driving IC products of

Macroblock, CHIPONE, Sumacro, Mingyang, IT, Bright

Way, Hangzhou Silan etc. are supported in cascading

mode;

17) Support full-color static to 32 scan;

18) Field frequency up to 60Hz;

19) With settable gray level and supports a maximum gray

level of 16bits 65536 grades;

20) Refresh frequency: A scanning screen is up to 3840Hz and

static screen up to 6000Hz;

21) Supports brightness and chroma calibration;

22) Able to connect multifunction card MFN300.

XI'AN NOVASTAR TECH CO., LTD

- 3-

PBOX150 Appearance

VIDEO

SWITCH

Audio and video switching button

The indicator light is on in HDMI mode

and off in asynchronous mode.

WiFi

Connecting antenna

SD CARD

Plugging SD card

Default IP

The factory default IP of PBOX150 is

192.168.0.220

100~240VAC.

50/60Hz

Power interface

PWR&RUN

Status

indicator

PWR: power indicator

RUN: signal indicator

LAN/WAN

100Mbps interface for connecting

control computer or accessing the

Internet.

USB

USB interface for plugging USB drives

XI'AN NOVASTAR TECH CO., LTD

- 4-

RESET

Factory reset button

TEMP

interface for temperature sensor

LIGHT

interface for light sensor

HDMI IN

HDMI input

HDMI LOOP

HDMI Loop output

AUDIO OUT

Audio output

LED OUT

Gigabit Ethernet port, LED output

BACKUP

Gigabit Ethernet port, LED backup

output

Network Connection

PBOX150 can be connected to play& control computer through

three methods: network cable, LAN and WiFi.

Method1 Network cable

Fig. 0-1Network cable

XI'AN NOVASTAR TECH CO., LTD

- 5-

Method2 LAN

Fig. 0-2 LAN

Method3 WiFi

Tip:

1) The WiFi function of PBOX150 has DHCP service which is

disabled and in route mode by default.

2) Please do not access PBOX150 into local area network by

network cables when DHCP is enabled. Because the DHCP

service of this card and DHCP service of routers in the

LAN will distribute IP address simultaneously, and then

conflict occurs.

3) When PBOX150 access external routers by searching

XI'AN NOVASTAR TECH CO., LTD

- 6-

hotspot, following router models are recommended to

guarantee connection: Huawei, TP-link, Tenda and

Netgear etc.

4) When bridge pattern is used, make sure that the upper

router has WDS function while bridging, otherwise

bridging will fail. Bridging among PBOX150 units is

supported. If bridging upper routers, you can confirm

whether the WDS of the router is enabled. Generally, it

defaults to enabled.

5) The default factory settings of control card are that DHCP

service is disabled.

6) The default factory settings of control card are in router

mode. Users could set it to bridging pattern through

webpage.

PBOX150 is integrated with WiFi function to enable wireless

communications. Meanwhile, it supports AP+Sta function. It

allows to build LAN while connecting public networks. So WiFi

deployment has the following four modes.

XI'AN NOVASTAR TECH CO., LTD