Nova Traveler 4900 User Manual

4900 Series

“Traveler” 3 Wheel Rolling Walker

User Guide

Specifi cations

Weight Capacity 250 lbs.

Weight 15 lbs.

Wheel Size 8”

Height Adjustment 30.25” -35.25”

Width Between Handles 12”

Approximate User Height 5’4” - 6’2”

Bag Dimensions 12”W x 9.5”D x 13”L

Basket Dimensions 10”W x 9”D x 9.5”L

Tray Dimensions 9.25”W x 8”D

Overall Dimensions 25”W x 24”D

Overall Dimensions (Folded) 27”L x 11”W x 26.5”D

Features

• Lightweight aluminum frame weighs
only 15 lbs.

• Large 8” wheels provide increased
maneuverability

• Locking hand brakes

• Tray, basket, and pouch

• Foldable

• Limited Lifetime Warranty

Safety Warnings

• Read walker guidebook before operating or using any Nova rollator.

• DO NOT exceed weight 250lb weight capacity.

• Care should be taken to ensure that all height adjustment knobs, castors, or any other moving objects
are in good working order before operating.

• Always contact your physician or therapist before using to determine proper adjustment and usage.

• Test the hand brake to make sure the brake pad engages and stops the unit and adjust if necessary

• DO NOT use on stairs, escalators, moving sidewalks or any uneven surfaces.

• DO NOT attempt to reach for items while using the walker. This motion may cause a change in weight dis­tribution and cause the walker to tip or become unstable.

• Always distribute your weight evenly on both handles when walking

• The rollator bag/basket has a weight capacity of 10 lbs. Items should not hang over the top or front of the
basket.

• Make sure walker frame is fully opened before use.
Always check hand brakes to ensure that they are working properly

• DO NOT remove warning sticker

FAILURE TO FOLLOW THESE INSTRUCTIONS CAN LEAD TO SERIOUS INJURY OR RESULT IN DEATH.
MISUSE OF THE WALKER MAY VOID WARRANTY.

Assembly Instructions

Step 1: Carefully remove the walker from the plastic bag and place on the fl oor

Step 2: Cut the 4 plastic ties that secure the handles to the frame and remove all foam protective pieces

Step 3: Open the walker up by grabbing the frame above the rear wheels and pulling outward so that the
walker forms a triangle (see image 1).

Step 4: Push down on the black hinge joint with caution markings until the frame is in the full open and
locked position (see image 2).

Step 5: Remove the rubber protection plugs from the top of the frame and insert the handles into the frame
(see image 3).

Step 6: Adjust the handles to your desired user height (see “Determine Correct Handle Height” on page 4).

Step 7: Once you have determined the correct height. Insert the screw into the hex screw cut out on the

inside of the frame and through the handle. Make sure that the hex screw head fi ts into the hex cut-out on

(see image 4).

Step 8: Place the contoured washer over the tip of the screw and hand tighten the black star adjustment
knob until it is fl ush with the frame (see image 5).

image 1

image 2

image 3

image 4