Notifier 301W User Manual

Vulcain 301W

Secondary headline

Wireless protection from CO and NO2
hazards without battery replacement,
calibration or maintenance for two years

Vulcain 301W
wireless gas detection
network

Technical summary

User Friendly

• Self-contained, wall mounted enclosure

• Simple push button operation

Easy and Inexpensive to Install

• Simply wall mount (no hardwiring required)

• Turn it on and the Vulcain 301W auto configures to the
controller and is fully operational

• Unobtrusive slim-line profile

• No mounting bracket required

Few Requirements - Simple Operation

• No calibration required for two years

• No monitor hardwiring required

• No battery replacement require for two years

• After two years, simply replace the easily removed
sensor/battery pack

Input/Output Adaptability

• Allows for up to 50 remote transmitters in the system

Safety Measures

• Virtually no false alarms—accurate and reliable

• Route redundancy, so if one link fails, communication
is automatically re-established through another monitor

• Avoids interference with Bluetooth, WIFI and other
wireless systems

• Secured 128 bit encrypted wireless mesh network

• Periodic ‘heartbeat’ signal ensures all transmitters are
continuously active

Beneficial Controller Options

• Datalogging option available

• Optional BACnet/IP Output

By removing the necessity for
expensive wiring and by greatly reducing
installation costs, the Vulcain 301W can cut
the bottom line for a parking garage’s CO
(carbon monoxide) monitoring system.

The Vulcain 301W wireless gas transmitter is
designed to detect carbon monoxide (CO) and
nitrogen dioxide (NO2) in parking structures or
oxygen (O2) in other applications. It operates for 2
years without calibration, maintenance or battery
replacement. The Vulcain 301W gas transmitter
exchanges data with the Vulcain 301C controller
over a wireless mesh network via a secured 128
bit encrypted communication protocol. In contrast
to traditional networks, this system offers greater
flexibility and operational reliability together with
significant installation and operational savings.
Without the need of monitor hardwiring, installation
costs are drastically reduced—simply wall mount
the Vulcain 301W transmitter, turn it on and it is
ready for operation.

Unlike point-to-point or point-to-multipoint
communication, if the communication path fails,
the system automatically finds an alternative
route. This enables continuous contact, even
in harsh environments. The inherent network
integrity combined with zoning capabilities and
electrochemical sensor accuracy minimizes false
alarms and ultimately trims operational costs.

Zoning / Averaging

The Vulcain 301C controller offers unique zoning
capabilities which permit the averaging and
comparison of multiple sensor readings. Zoning can
reduce operational costs by ensuring that localized
brief fluctuations registered at a single transmitter
do not activate relays. For example, a car idling in
a parking structure may locally increase a reading
at a nearby transmitter. Rather than activating a fan
as a result of the temporary localized fluctuation,
zoning can be used to limit relay activation until the
average reading for a zone exceeds a set-point.
This can reduce run time of fans, yielding savings in
both energy usage and wear and tear. The Vulcain
301C has the capacity to manage input from three
Modbus channels for up to 96 transmitters and up
to 50 wireless transmitters which can be associated
with up to 126 zones. Transmitters can belong to
an unlimited number of zones, providing maximum
operational and control flexibility.

Vulcain 301W General Specification

Uses

the Vulcain 301C controller.

Power Requirement Battery operated with 2 years (minimum)

Size 22.5 x 10 x 5.7 cm (8.85 x 4 x 2.25 in.)

Weight 0.4 kg (0.88 lb.)

Sensing Technology Electrochemical

Network Capacity 50 wireless transmitters to the Vulcain 301C

Visual Indicators Two LEDs

Radius of Detection 15.24 m (50 ft.)

Calibration Not required for 2 years

Communication Protocol 2.4 Ghz - IEEE 802.15.4 - Secured 128-bit encryption

Alarms Centralized alarm management via Vulcain 301C wireless controller

Ratings and Certifications:

Conforms to

Certified to CAN/CSA C22.2 No. 61010-1

FCC Part 15 Subpart C(15.247)
RSS 210 Section 6.2.2(o)

Enclosure NEMA 4X Polycarbonate – ABS

Vulcain 301C General Specification

Uses

sensors (up to 50 Vulcain 301W transmitters) with relays for effective response to hazard(s) present (activation of ventilation
fans, audible and/or visual alarms, etc).

Power Requirement 17-27 Vac, 24-38 Vdc, 500 mA

Size 28 x 20.3 x 7 cm (11.02 x 7.99 x 2.76 in.)

Weight 1.1 kg (2.4 lb.)

Network Capacity Three Modbus channels for up to 96 wired transmitters and up to 50 wireless transmitters

Optional BACnet capacity

Communication Line Lengths Up to 609 m (2000 ft.) per channel
(RS-485) T-Tap: 20 m (65 ft.), maximum per T-Tap

40 m (130 ft.) maximum for all T-Tap combined
30 m (100 ft.) between each 301W

Relay Output Rating 5 A, 30 Vdc or 250 Vac (resistive load)

Alarm Levels 3 fully programmable alarm levels

Time Delays 0, 30 sec., 45 sec., 1-99 minutes before and after alarm; latchable

Outputs 4 DPDT relays (alarms and/or fault); 65dBA buzzer

Display Large 122 x 32 dot matrix display

Operating Humidity

Operating Temperature -20 to 50°C (-4 to 122°F)

Ratings and Certifications:

Certified to CAN/CSA C22.2 No 61010-1

116662

Conforms to ANSI/UL 61010-1
IEC 61010-1 Including Amendments A1:1992 +
A2:1995 and National Deviations (Canada, US)

Wall mounted, wireless gas detector for carbon monoxide (CO) hazards, to be used in conjunction with

ANSI/UL 61010-1

Wall mounted gas detection control panel for the annunciation of gas hazards detected by the complete range of Vulcain

0-95% RH, non-condensing

Find out more

For more information on Honeywell
Analytic’s Vulcain line of products, visit
www.honeywellanalytics.com or contact
us at 800 563 2967

Customer business center
Canada

Honeywell Analytics
4005 Matte Blvd., Unit G
Brossard, QC, Canada
J4Y 2P4
Toll free: [phone]
Tel: [phone]
Fax: + 1 888 967 9938
[e-mail]
www.honeywell.com

Customer business center
USA, Central and South America

Honeywell Analytics
Suite 100
400 Sawgrass Corporate Parkway
Sunrise, FL
33325
Tel: [phone]
Toll free: [phone]
Fax: [phone]
[e-mail]
www.honeywell.com

Customer business centre
Europe and the rest of the world

Honeywell Analytics
Wilstrasse 11-U11
CH-8610 Uster
Switzerland
Tel: [phone]
Fax: [phone]
[e-mail]
www.honeywell.com

As world leaders in gas detection solutions, Honeywell Analytics’ Vulcain
range of gas detection systems has been designed to provide efficient,
practical and cost-effective equipment to protect people from a variety
of forms of hazardous gases and to efficiently monitor and control indoor
air quality. The equipment is also extremely simple to install and easy to
operate and maintain.

Vulcain 301WVulcain 201TVulcain 301RLC

The Vulcain range of fixed gas detection and air monitors

GasPoint II

Vulcain 301M

Vulcain Controllers

Designed for industrial or commercial use, the Vulcain 301C monitors
and controls toxic gases, combustible gases and oxygen hazards.
With the same simple installation and operation and flexibility as the
Vulcain 301C, the Vulcain 301EM is specifically designed to fulfil the
requirements of a mechanical room.

Vulcain Sensors

From refrigerants to toxic and combustible gases, Honeywell Analytic’s Vulcain line has a sensor designed for any industrial or commercial
application. With award winning sensor technology, this line of sensors is the answer to any fixed HVAC, IAQ or gas detection concerns.

Stand-Alone Dual Gas Monitor

For applications where gas detection is only needed at one or two
points, the Vulcain 301M offers a simple solution. While continually
monitoring for CO, a remote sensor can also be integrated to
detect CO, NO2, propane, hydrogen or methane with a remote
sensor that can be place up to 200’ away.

Vulcain 90DM

4

Commercial CO2 Detection

Using proven infrared dual sensing technology to detect carbon
dioxide (CO2) the Vulcain 90DM4 can be either wall or duct
mounted to monitor CO2 levels in you commercial environment.

Vulcain 301C Vulcain 301EM

H_301W_DS01011_V1

September 2006

©2006 Honeywell Analytics