
NORTHSTAR TRAILERS
Assembly Guide for LOADSTAR Trailer
Congratulations! You are the proud owner of a NORTHSTAR trailer. Please follow
the instructions and steps in this manual for proper assembly. You may also watch
our assembly video on You Tube by typing in Northstar Trailer assembly.

Tongue (with wiring harness)
and Coupler (hitch)
7 7 Wheel and Hub Assembly
3 5/8” threaded Pin-Bolts
2 M Taillight/Brake Light
Taillight/Brake Light L-Bracket
Small Brass Screw (included in
bag with blue wire connectors)
TRAILER PARTS LIST
HARDWARE
Make sure that all parts, as listed above, are included in your shipment. If any parts
are missing please contact NORTHSTAR at 1-855-375-3088.
Other tools needed for assembly: grease gun, flathead screwdriver, socket set,
wrench set, small zip-ties, small rubber mallet.

IMAGES OF PARTS AND HARDWARE
***Spare tire mount may be located on the bottom side of the tongue so that
accessories such as a gas can rack may be added.***

INVERTED ASSEMBLY
This trailer requires inverted assembly. (Assembled upside-down). Start by turning
the trailer frame upside-down so the trailer deck is facing the ground. Use a table
robust enough to support the weight of the trailer frame and high enough to elevate
the frame to waist-height, or place the corners of the frame on buckets, or use
sawhorses to elevate each end.
CAUTION: This trailer is heavy. More than one person is required to flip the trailer
frame and assembly this trailer. Personal injury may occur if you try to assemble this
trailer alone.