RETURN TO SERVICE PROCEDURE TABLE OF CONTENTS
Field Service Procedure
A-Cone Switch Installation
Anesthesia
RETURN TO CD-ROM TABLE OF CONTENTS
Emergency Care • OR/ Anesthesia • Critical Care • Home Care
Revision 3/24/04
SP00313
Because you care
RETURN TO SERVICE PROCEDURE TABLE OF CONTENTS
RETURN TO CD-ROM TABLE OF CONTENTS
Service Procedure A-Cone Switch Installation
A-CONE SWITCH
INSTALLATION
1GENERAL INFOR-
MATION
This document contains warning statements.
– WARNING statements provide important information which, if ignored,
could lead directly to a patient’s injury.
WARNING
Any person involved with the setup, operation, or maintenance of the
Fabius GS® or Fabius Tiro® anesthesia machine must be thoroughly
familiar with the instruction manual for this product.
2 INTRODUCTION The A-Cone Switch provides the means for switching the fresh gas flow
between two separate patient circuits without changing the fresh gas hose
connections.
The purpose of this Service Procedure is to support the installation of the ACone Switch. An Auxiliary Fresh Gas Outlet must be in place on the anesthesia machine prior to the installation of the A-Cone Switch.
3 KIT CONTENTS Inspect the A-Cone Switch Installation Kit to verify that it contains the follow-
ing:
PART NUMBER DESCRIPTION
4 A-CONE SWITCH
INSTALLATION
4118760 A-Cone Switch Asm
4118756 Supplement to Operator’s
Manual
SP00313 Service Procedure
1. Verify that the Fabius GS or Fabius Tiro machine is in ‘Standby’ mode and
all flow control valves are closed.
NOTE;
Location of the Auxiliary Fresh Gas Outlet Assembly will depend on the
specific configuration of the Fabius GS or the Fabius Tiro machine currently being serviced. The Auxiliary Fresh Gas Outlet Assembly will be
located on either the right or left hand side of the machine.
2. Disconnect hose (2600170) from the front conical connector on the auxiliary fresh gas outlet assembly. Refer to Fig. 1 for typical configuration and
identification of parts.
All rights reserved. Copyright reserved.
SP313.fm 20.04.04
Dräger Medical, Inc. SP00313 Revision - Released
1