Documentation Release Note Number: MSC-0803-035
CSQI/CSQO prompts modified in LD 17
Customer Service Report Number
NTP Number
Software Release
Description
In Software Input/Output: Administration (553-3001-311), the CSQI and
CSQO responses and descriptions are incorrect.
In Software Input/Output: System Messages (553-3001-411), the system
message SCH5553 is missing.
• Figure, table, procedure, and page numbers shown below are subject
to change in the next standard release of documentation.
• Text shown below in strikethrough has been replaced or removed.
Q00645021
553-3001-311
553-3001-411
Meridian 1 Release 25.40
Succession CSE 1000 Release 2.0
IMPORTANT!
Nortel Networks 28 August 2003 1 of 3
Documentation Release Note Number: MSC-0803-035
Correction
Revision in Software Input/Output: Administration
(553-3001-311), Standard 10.00
Revised entry: “LD 17: Configuration Record 1”, page 499
Alphabetical list of prompts
Prompt Response Comment Pack/Rel
... ... ...
CRC 1-(10)-20 CRC threshold. Enter in units of 5 per cent.
CRC establishes the % of Cyclic Redundancy Code
(CRC) errors detected in 15 minutes before an
out-of-service threshold is enforced.
CRC = (# of packets retransmitted) ÷ (total # packets
sent).
cls-7
CSQI (20) - x Maximum number of call registers for CSL input
queues. Where:
x = 25% of NCR
If AST is enabled, set CSQI equal to the larger value
of the following:
1. Number of ACD agents or AST sets to be
controlled by the host computer, or
2. 50.
Note: These call registers are used for Command and
Status Link applications such as Meridian Link.
Nortel Networks 28 August 2003 2 of 3
cls-7
Loading...