8
9
Install Washing Machine
Install Washing Machine
Install Inlet Pipe
1.Connect the elbow to the tap and fasten it clockwise.
Notes: after connection, if there are any leakages in the hose, repeat the
steps to connect the inlet pipe. Check that hose hasn't been kinked or
crushed. Do not modify or sever the water inlet hose.
Unpacking the washing machine
Unpack your washing machine and check if there has been any damage during the
transportation. Also make sure that all the items (as shown on Page 7) in the attached bag are
received. If there is any damage to the washing machine during the transportation, or if there are
any items missing, please contact the NordMende customer service team.
Dispose the packing materials
The packing materials of this machine may be dangerous to children. Please dispose of
them properly so that they are out of the reach of children. Dispose the related packing
materials according to the relevant local regulations. Please do no throw the packing
materials away together with daily household rubbish.
Remove transport bolts
Before using this washing machine, transport bolts
must be removed from the underside of this machine.
Please take the following steps to remove the bolts:
1. Loosen all bolts with a spanner and then remove them.
2. Plug the holes with transport hole plugs.
3. Keep the transport bolts safely for future use.
Select the location
Before installing the washing machine, the location characterised as follows shall be
selected:
- Rigid, dry, and level surface (if not level, please make it level by referencing the
following figure “Adjust Leg”)
- Avoid direct sunlight
- Sufficient ventilation
- Room temperature is above 0 C
- Keep far away from heat sources such as coal or gas.
- Make sure that the washing machine is not standing on the power cord.
- Do not install the washing machine on a carpeted floor.
Adjust Leg
1. When positioning the washing machine, check
that the legs are screwed up to their shortest
point. If not, please turn them to their original
positions with your hand or spanner and tighten
the nuts with a spanner.
2. After positioning the washing machine, press
all four corners on the front of the machine in
sequence. If the washing machine is not stable
when pressed, adjust the appropriate leg.
3.Loosen the lock nut with spanner and turn the leg by hand until it closely contacts the floor. Press the
leg with one hand and fasten the nut closely to the underside of the machine with the other hand.
4.After being locked properly, press all four corners of the machine again to make sure that it has been
adjusted properly. If it is still unstable, repeat steps 2 and 3.
2
3
4
1
Rai se
Low er
Loc k nut
foo t
Connect the inlet pipe as indicated, between an ordinary tap and inlet hose.
Connect Water Supply Hose
− To prevent leakage or water damage, follow the instructions in this chapter.
− Do not kink, crush, modify or sever the water inlet hose.
− For the models equipped with a hot valve, connect it to hot water tap with hot water supply hose.
Energy consumption will decrease automatically for some programmes.