Safety Reset Button
Use your finger or a pencil to press the button in until you feel it click.
15 16
MAINTENANCES
MAINTENANCES
Trouble Shooting
Filter clean
• Clean the lint filter after each use.
Remove it by pulling straight up.
• Clean the filter by using a cloth or
or your fingers, to wipe clean.
Install filter
• If the filter is cleaned with a damp
cloth or water, please allow to dry
before installation.
Cleaning cabinet and inner tube
• Use a soft damp cloth to wipe clean the
cabinet and inner tube.
• Do not to rinse directly under water.
• Do not use a scouring / abrasive sponges.
• Do not use chemical based or alcohol wipes.
• Leave the dryer door open to dry cleaning the
inner tube.
Safety reset
• These dryers have a safety cut out switch which is activated by the
temperature.
• The safety reset button is on the backboard. If your dryer is not heating,
this button must be reset before the dryer can heat again. You may need
to wait 10 minutes for it to cool down.
• The most common reason for the dryer overheating, is a blocked filter.
• Clean the line filter after each load to prevent overheating of the dryer
The cut out switch may operate for the following reasons:
• The lint filter is blocked.
• The exhaust outlets are blocked at the back of the dryer.
• Poor ventilation in the laundry or room; open a window or door
• Lightweight garment eg. handkerchief, sucked onto the filter.
Cleaning And Care
Trouble Cause
Solution
Will not start
Hot service
or burning
smell
Clothes
too dry
Clothes
shrink
Lint on
clothes
• Power cut.
• The power plug is not
plugged in securely.
• Dry clothes exceed the maximum
load.
• The temperature fuse is cut.
• The lint filter is dirty.
• The uptake or exhaust
duct is dirty.
• The machine is too full.
• Clothes left in the dryer for a
prolonged period
• The temperature used is too
high.
• The temperature used was too
high dry.
• Fabrics can develop lint balls do
to excessive friction.
• Wait for or turn on the electricity, check trip switch.
• Check the power socket, make sure the plug is in
tight.
• The clothes in dryer must be after a spin cylce in the
washing machine and can not exceed 7kg.
• Replace the fuse.
• Clean out the lint filtersure clean the lint filter
• Clean out uptake or exhaust duct.
• Make sure not to over fill the machine.
• Make sure that you take out the clothes
immediately when finish.
• Observe the maintenance label on clothes.
• Observe the maintenance label on clothes.
• Take out the clothes when still a little damp before
they become too dry, then hang the clothes until
fully dry.
• Use fabric softener when washing your
clothes. Turn the garment inside out to reduce
friction and rubbing to the front of the
garment.