Replacing The Light Bulb ................................................................................................. 7
TRANSPORTATION AND CHANGING OF INSTALLATION POSITION ............... 7
Changing of Door Opening Direction .............................................................................. 7
BEFORE CALLING YOUR AFTER SALES SERVICE .......................................... 8
THE PARTS OF THE APPLIANCE AND THE COMPARTMENTS ....................... 10
UK - 1 -
PART- 1.
BEFORE USING THE APPLIANCE
Safety Instructions
• If the model contains R600a-see name plate under refrigerant (the coolant isobutene),
naturals gas that, is very environmentally friendly but also com bustible. When
transporting and installing the unit care must be taken to ensure that none of the
refrigeration circuit components become damaged. In the event of damage avoid
naked flames or ignition sources and ventilate the room in which the unit is placed
for a few minutes.
Warning: Keep ventilation openings in appliance enclosure or in structure for building
in, clear of obstruction.
• Do not use mechanical devices or other artificial means to accelerate the defrosting
process.
• Do not use electrical appliances in the refrigerator or freezer compartment of the
appliance.
• If this appliance is to replace an old refrigerator with a lock; break or remove the lock
as a safety measure before storing it, to protect children while playing might lock
themselves inside.
• Old refrigerators and freezers contain insulation gases and refrigerant, which must
be disp osed of pro p erly. Entrust th e dispo sal of a scrap unit categorically to
competence of your local waste disposal service and contact your local authority or
your dealer if you have any questions. Please ensure that the pipe of work of your
refrigerating unit does not get damaged prior to being picked-up by the relevant waste
disp osal service.
Important note:
Please read this boo klet before installing an d switch ing on this appliance. The
manufacturer assumes no responsibility for incorrect installation and usage as described
in this booklet.
Conformity Information
• Tropical Class is defined for the environment temperatures between 16°C and 43°C
in accordance with the TS EN ISO 15502 Standards.
• The ap p liance is designed in co m p li ance with the EN15502, IEC60335-1 /
IEC60335-2-24, 2004/108/EC standards.
Please ask your municipal authority about the disposal of the WEEE
for the reuse, recycle and recovery purposes.
UK - 2 -
Recommendations
Warning: Do not use mechanical devices or other means to accelerate the defrosting
process, other than those recom mended by the manu facturer. Do not use electrical
appliances inside the food storage compartments of the appliance, unless they are of
the type recommended by the manufacturer. Keep ventilation openings, in the appliance
enclosure or in the built-in structure, clear of obstruction. Do not damage the refrigerant
circuit.
• Do not use adapters or shunts, which could cause overheating
or burning.
• Do not plug old, warped power supply cables.
• Do not twist and bend the cables.
• Do not allow children to play with the appliance. Children must
NEVER sit on drawers or hang from the door.
• Do not use sharp metal objects for removing ice on the freezer
compartment; they could puncture the refrigerator circuit and
cause unrepairable damage to the unit.
• Do not plug the power supply with wet hands.
• Do not place containers (glass bottles or tin containers) of liquids
into the freezer especially gassy liquids as they could cause
the container to burst during freezing.
• Bottles that contain a high percentage of alcohol must be sealed
well and placed vertically in the refrigerator.
• Do not touch the cooling surfaces, especially with wet hands as
you could be burnt or hurt.
• Do not eat ice, which have just been removed from the freezer.
• The appliance is not intended for use by people (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by
a person responsible for their safety. Children should be supervised to ensure that
they don’t play with the appliance.
• If the supply cord is damaged it must be replaced by the manufacturer or service
agent or similarly qualified people in order to avoid a hazard.
UK - 3 -
Installation and Switching On The Appliance
• This appliance is connecting to 220-240V or 200-230V and 50 Hz. Please check
nameplate of appliance and be sure voltage range suitable to your mains voltage.
• Before making the connection to the power supply, ensure that the voltage on the
nameplate corresponds to the voltage of electrical system in your home.
• Insert the plug into a socket with an efficient ground connection. If the socket has no
ground contact or the plug does not match, we suggest you to call an authorised
electrician fo r assistance.
• The plug should be accessible after the appliance is positioned.
• Manu facturer is not responsible for failure to complete the
ground connection as described in this booklet.
• Do not place the appliance in direct sunlight.
• Do not use in open air and shall not be exposed to the rain.
• Place the ref rigerator far from heat sourc es and in a wellventilated position. The refrigerator should be at least 50 cm
from radiators,gas or coal stoves and 5 cm far from electrical
sto ves.
• Keep the top free for at least 15 cm.
• Do not place heavy and lots of things on the appliance.
• If the appliance is installed next to another refrigerator or freezer,
observe a minimum distance of 2 cm to prevent condensation.
• Do not put very ( !) hot food or bowl on the top table.It can damage
the toptable.
• Fit the plastic wall spacers to the condenser at the back of the
refr igerator in order to prevent leanin g to the wall for good
performance.
• The appliance must be stand firmly and level on the floor Use
levelling-feet to compensate for an even floor.
• The outside of the appliance and the accessories inside should be cleaned with a
solution of water and liquid soap ; the inside of the appliance with sodium bicarbonate
dissolved in lukewarm water. After drying replace all the accessories.
Before Switching On
• W ait after 3 hours before plugging the appliance in to the power to
ensure proper performance.
• There can be an odour when you first switch on the appliance. It
will disappear after the appliance starts to cool.
UK - 4 -
PART- 2.
THE VARIOUS FUNCTION AND POSSIBILITIES
Thermostat Setting
• Therm ost at aut omatically regulat es the inside temperature of the refrigerator
compartment and freezer compartment.By rotating the knob from position 1. to 5.,
colder temperatures can be obtained.
• « • » position shows thermostat is closed and no cooling is available.
• For short-term storage of food in the freezer compartment, you can set the knob
between minimum and medium position.(1-3)
• For long-term storage of food in the freezer compartment, you can set knop medium
position.(3-4)
Note that; the ambient temperature, temperature of the freshly stored food and
how often the door is opened, affects the temperature in the refrigerator compartment.
If required,change the temperature setting.
• W hen you first switch on the appliance, for starting a suitable cooling, the appliance
should work 24 hours continuously until it cools down to sufficient temperature.
• In this time do not open the door so often and place a lot of food inside the appliance.
• If the unit is switched off or unplugged, you must allow at least 5 minutes before
restarting or re-plugged the unit in order not to damage the compressor.
• Larders (coolers) have not any freezer compartment but can cool up to 4-6°C.
UK - 5 -
PART- 3.
• Disconnect unit from the power supply before cleaning.
• Do not clean the appliance by pouring water.
• The refrig erator co m p artment sh ou ld be c lean e d
periodically using a solution of bicarbonate of soda and
lukewarm water.
• Clean the accessories separately with soap and water Do
not clean them in the washing machine.
• Do no t use abrasive products, detergents or soap s.After
washing, rinse with clean water and dry carefully. W hen the
cleaning operations have been completed reconnect the
plug of the unit with dry hands.
• You should clean the condenser with broom at least twice
a year in order to provide energy saving and increase
the productivity.
CLEANING AND MAINTENANCE
Defrosting
• Defrosting occurs automatically in refrigerator compartment during operation ; the
defrost water is collected by the evaporating tray and evaporates automatically.
• The evaporating tray and the defrost water drain hole should be cleaned periodically
with defrost drain plug to prevent the water from collecting on the bottom of the
refrigerator instead of flowing out.
• You can also pour ½ glass of the water to drain hole to clean inside.
UK - 6 -
Replacing The Light Bulb
When replacing the light of the refrigerator compartment;
1. Unplug the unit from the power supply,
2. Press the hooks on the sides of the light cover top and remove the light cover
3. Change the present light bulb with a new one of not more than 15 W.
4. Replace the light cover and after waiting 5 minutes plug the unit.
PART- 4.
TRANSPORTATION AND CHANGING OF
INSTALLATION POSITION
Transportation and Changing of Installation Position
• The original packages and foamed polystyrene (PS) can be concealed if required.
• In transportation the appliance should be tied with a wide stripe or a strong rope.
The rules written on the corrugated box must be applied while transporting.
• Before tr a nspo r tin g o r c h an g in g o ld
installation position, all the moving objects
(ie,shelves,crisper…) should be taken out
or fixed with bands in order to prevent the
shake.
Changing of Door Opening Direction
In case you need to change door-opening direction, please consult the domestic after
sales service.
(In some models)
UK - 7 -
Loading...
+ 16 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.