Nordic Start NS-1000 SH User Manual

Will automatically lock the doors when the key is turned to the on position and the brakes are pressed. When the ignition key is turned to the off position, the doors will automatically unlock.
PROGRAMMING OPTIONS
PROGRAMMING OPTIONSPROGRAMMING OPTIONS
PROGRAMMING OPTIONS
The following can be programmed by your dealer:
Engine run time: 5, 15 or 25 minutes.
Maximum crank time: 6, 8 or 12 seconds
Child proof feature
Trunk release or Garage door control.
Idle mode feature.
DIAGNOSING PROBLEMS
DIAGNOSING PROBLEMSDIAGNOSING PROBLEMS
DIAGNOSING PROBLEMS
Poor transmitting range
There are many factors which affect operating range. Some of these are:
Battery condition
Operating environment (Downtown RF noise)
Metal: any type of metal will affect operating range. Range in a
crowded parking lot will be significantly lower than open space.
Transmitter orientation: always hold the transmitter high;
approximately shoulder height. Holding the transmitter under the chin will improve performance. Try it!
Engine does not start
If the engine does not start, check the following:
Is the transmitter LED working? If not, check the battery .
Are you pressing the transmitter long enough? Press the transmitter
until the parking lights activate.
Check the valet switch. When the power is turned ON, the parking
lights will flash twice to confirm power up.
VALET MODE
VALET MODEVALET MODE
VALET MODE
Autostart is equipped with a valet switch (ON/OFF) make sure that all users of the vehicle know the location of the switch. * To put the unit into Valet mode, simply turn the under dash switch to OFF (system should now be in valet)
BASIC REMOTE OPERATIONS
BASIC REMOTE OPERATIONSBASIC REMOTE OPERATIONS
BASIC REMOTE OPERATIONS
The remote control unit has two buttons. Button 1, is used for remote keyless entry. Button 2, serves to start the vehicle. Button I & II, Is for the convenience of remote trunk release. To start the car by remote, you must ensure that the hood is closed and that the Valet switch is in the ON position. Press button 2, for about 1 second (or 4 to 5 if the Child Proof feature was enabled by your installer). Once the button has been pressed the parking light will come on to inform you that the unit has received your signal, and has begun the start process. The car should be running after about 5 sec. The vehicles parking lights will stay on the entire pre-programmed run cycle. NOTE: Do not continue to press the remote once the parking lights activate. Pressing the remote continuously for 4 seconds will activate “Cold Weather Mode” and will Not start the engine. If the vehicle doesn’t start, the Autostart will shut off, wait a few seconds, then re­try to start the engine again. The Autostart will try to start the engine a total of 2,3 or 4 times (programmable) before giving up. With the vehicle running under remote control, enter the vehicle. Insert the key in the ignition and turn the key to the “ON” position. Do not turn the key to the
“START” position with the engine running, this w ill cause the starter motor to reengage. NOTE: Do not forget to leave the heather or air conditioner turned on before
leaving your vehicle. So that your vehicle can be “PRE-WARMED” or “PRE­COOLED” by remote control.
REMOTE DOOR LOCKS
REMOTE DOOR LOCKSREMOTE DOOR LOCKS
REMOTE DOOR LOCKS
If your system was installed with remote door locks, you will have the convenience of remote keyless entry.To UNLOCK you doors, press and hold button 1 for about
USER-GUIDE
USER-GUIDE
USER-GUIDE
USER-GUIDENS-1000 SH
NS-1000 SHNS-1000 SH
NS-1000 SH
1 sec. Once the doors have unlocked the parking lights will flash twice to confirm that the doors are unlocked. (Also disarming your starter kill.) To LOCK your doors, press Button 1 on your remote. When the doors have locked, the parking lights will flash once. (Arming the starter kill.)
REMOTE TRUNK RELEASE OR GARAGE DOOR
REMOTE TRUNK RELEASE OR GARAGE DOORREMOTE TRUNK RELEASE OR GARAGE DOOR
REMOTE TRUNK RELEASE OR GARAGE DOOR CONTROL
CONTROLCONTROL
CONTROL
The Autostart has the ability to control the trunk release or an external garage door opener system. (Option). If your Autostart was installed with the power trunk release option, you can pop your trunk with button 1 & II of the remote transmitter. If your Autostart was installed with the garage door option, the garage door can be opened by simply pressing on button I & II when in front of the garage door.
STARTER KILL OPTION
STARTER KILL OPTIONSTARTER KILL OPTION
STARTER KILL OPTION
If your Autostart was installed with the starter kill option, you will not be able to start your vehicle with the keys unless the system has been disarmed first. This option works with the door lock sequence. If you did not get the door locks installed, ignore the reference to the door locks operation below. To disarm the starter kill system, press and hold Button 1 to unlock the doors. When the system has been disarmed, you will get two quick flashes through the parking lights. NOTE: Locking the doors will rearm the starter kill unit. Once the system has been disarmed, you will have approximately 45 seconds to insert the key in the ignition, turn it to the on position and start the engine. Once the engine has been turned off, the system will
rearm in 45 sec.
IDLE MODE OPTION
IDLE MODE OPTIONIDLE MODE OPTION
IDLE MODE OPTION
The Idle Mode Option can be enabled by your installer so that you can leave the vehicle unattended and the engine running for the engine run time. This is handy when you need to make a short stop or delivery without having to stop the engine and restart it. If your stop is longer then the engine run time, the engine will shut off automatically like on a re mote start. If Idle Mode was enabled at installation, you can activate Idle Mode by completing the following steps:
1. Ensure that the engine is running.
2. Hold button 2 for at least 3 sec. Parking lights will flash and stay on.
3. Remove key from ignition.
4. Exit the vehicle and lock the doors.
SAFETY FEATURES
SAFETY FEATURESSAFETY FEATURES
SAFETY FEATURES
Autostart is equipped with a valet switch (ON/OFF) make sure that all users of the vehicle know the location of the switch. You should turn the switch OFF when:
Servicing Vehicle
Parking indoors (garage)
If there are problems with the remote starter.
When the switch is turned on, the parking light will flash twice to confirm that the car-starter is in operation. Autostart is equipped with a pin switch in the engine compartment. When the hood is raised, the 1200 is disabled. A faulty pin switch can disable the remote starter. Make sure the pin switch is in good working condition for reliable starts.
COLD WETHEAR STARTS
COLD WETHEAR STARTSCOLD WETHEAR STARTS
COLD WETHEAR STARTS
The Autostart has a feature that allows your vehicle to start every two hours for 5 minutes. This helps keep the engine warm during c old weather and makes starting easier. To place the Autostart into cold weather mode, press and hold button 2 for about 5 sec. Note: that if Child Proof Operation was enabled, then Button 1 + 2 will have to be pressed in order to activate cold weather mode. When the unit has gone into Cold Weather Mode the parking lights will flash 3 times quickly. You can cancel cold weather mode by doing the following:
Turn ignition key to the on position.
Start the vehicle by remote.
Open the hood.
The unit will automatically cancel Cold Weather Mode after starting the engine 12 times.
CHILD PROOF OPTION
CHILD PROOF OPTIONCHILD PROOF OPTION
CHILD PROOF OPTION
The child proof option can be enabled by your installer so that you must press and hold button 2 for about 5 sec. In order to star the vehicle. The Child Proof Option can be another security feature that you can use if you are concerned b y the possibility of st arting your car without wanting it by briefly pressing Button 2.
IGNITION LOC K
IGNITION LOC KIGNITION LOC K
IGNITION LOC K
This feature can be turned on by programming the Autostart. If this feature has been activated, the Autostart
Loading...