Page 1
Super Stack
(Little Stack Wireless + Big Stack)
Page 2
Page 3
Product Name: Little Stack Wireless
Product type: Rechargeable power bank
Model No: M8.C3.2Z/M9.C1.2Z/M10.C3.T10.3Z
Ratings: Input: PIN 5V 1.6A / USB-C 5V 2.1A
Output: Wireless Coil 7.5W → 3.7V/5000 mAh 18.5Wh /
USB-C 5V 2.1A
Product Name: Big Stack
Product type: Rechargeable power bank
Model No: M8.C3.2Z/M9.C1.2Z/M10.C3.T10.3Z
Ratings: Input: USB-C PD 5V 3A 9V 3A 15V 3A 20V 3A (max)
60W 5-100W
Output: USB-C PD 5V3A 9V3A 15V3A 203VA 60W (max)
2xUSB-A 5V 2.4A (max) / PIN 5V 1.6A → 20,000 mAh (5000
mAh 14.8V) 74Wh
Product Name: 87 W Cable (USBC - USBC 2m)
Product type: Cable
Model No: M10.C3.T10.3Z
Warranty
At Nolii, we are dedicated to making the best quality
products. To back this up, this product is warranted for 1 year
from the date of purchase. This warranty does not affect any
statutory rights that you may be entitled to. Keep a copy of
your purchase receipt as proof of purchase. Be sure to register
your product at www.wearenolii.com. Failure to register
your product and/or provide proof of purchase may void the
warranty.
Exclusions & Limitations
Except for the limited warranty expressly set forth or to
the extent restricted or prohibited by applicable law, Nolii
expressly disclaims any and all other warranties express or
implied, including any warranty of quality, merchantability,
or tness for a particular purpose, and you specically agree
that Nolii shall not be liable for any special, incidental,
indirect, punitive, or consequential damages for breach of any
warranty of any type on any Nolii product. In addition to and
without limiting the generality of the foregoing disclaimers,
the limited warranty does not, under any circumstance, cover
the replacement or cost of any electronic device or personal
property inside or outside of the Nolii product.
Customer Service
Email: hello@wearenolii.com
Web: www.wearenolii.com
WARNING!
Read all instructions and warnings prior to using this
product. Improper use of this product may result in product
damage, excess heat, toxic fumes, re or explosion, for
which damages you (“Purchaser”) and not Nolii Ltd (“
Manufacturer”) are responsible.
EN
Risk of re and burns.
Do not open, crush, heat above 40°C or incinerate.
Do not short circuit. Avoid storage in direct sunlight.
Do not subject cells or batteries to mechanical shock.
Retain the original product literature for future reference.
Use only in the application for which it was intended.
Dispose of properly.
For indoor and dry location use only.
Instructions for Use
Use Big Stack to charge multiple devices using the 1 x USB-C
and 2 x USB-A ports. Use Little Stack to charge wirelessenabled devices using the wireless surface, or compatible
devices via the USB-C port which functions as both an input
and output.
The battery functions using a capacitive button indicated in
the illustrations on page 2. This button allows you to activate
four different function modes;
Ȳ On: Touch and hold for 5 seconds to turn Big Stack on
Ȳ Status: Touch once to check remaining battery charge
levels
Ȳ Off: Touch and hold for 5 seconds to turn off. In this
mode, you can still use Big Stack’s USB-C output.
Initial Setup
Ȳ Charge Big Stack and Little Stack to 100% by placing
Little Stack on top of Big Stack and charging both via
Big Stack’s USB-C input. Big Stack will charge Little Stack
magnetically.
Ȳ The LEDs will ash showing the power level of Big Stack
Ȳ Big stack will remain on until it is turned off
BIG STACK
Charging Big Stack
Ȳ Insert one end of the 87W USB-C - USB-C cable into
Big Stack
Ȳ Insert the other end of the cable into a USB-C power
source (i.e. MacBook adaptor)
Ȳ LEDs will ash until Big Stack is fully charged, at which
point they will remain constant
Charging a Compatible USB-C Laptop
Ȳ Use the 87W cable to connect Big Stack’s USB-C output
to your laptop
Ȳ Big Stack will charge via the USB-C output regardless of
whether it is turned on
Charging Other Devices from the USB-A Ports
Ȳ Plug your device into any of the USB-A outputs
Ȳ If in Standby mode, one press of the capacitive button will
initiate Charge mode
Ȳ LEDs are lit for duration of charge, indicating Big Stack’s
remaining charge level
Page 4
Turning Big Stack Off (to conserve battery life)
Ȳ Press and hold the capacitive button on the front of
Big Stack for 5 seconds to switch off
Checking Big Stack Charge Level
Ȳ Press the capacitive button on the side of the battery
Ȳ The LEDs will indicate the level of charge remaining in
the battery
Ȳ After 20 seconds, the lights will switch off
LITTLE STACK
Charging Little Stack
Ȳ Charge Little Stack magnetically by placing on top of
Big Stack and putting Big Stack into Charge Mode
Ȳ When Big Stack is connected to mains power, magnetic
charging will begin automatically
Ȳ Alternatively, charge Little Stack via the USB-C input by
rst inserting the USB-C end of the cable into Little Stack
Ȳ Insert the USB-A end of the cable into a power source
Ȳ LEDs will ash until Little Stack is fully charged
Turning Little Stack On
Ȳ Place your wireless charging enabled phone on top of
Little Stack
Ȳ Press the capacitive button on the side of the battery to
begin charging
Ȳ LEDs are lit for duration of charge, indicating Little Stack’s
remaining charge (4 = 100%, 3 = 75%, 2 = 50%, 1 = 25%)
Turning Little Stack Off
Ȳ Little Stack will automatically turn off once your phone
battery reaches full capacity
Ȳ Or remove your phone from Little Stack to disconnect
Checking Little Stack Charge Level
Ȳ Press the capacitive button on the side of the battery
Ȳ The LEDs will indicate the level of charge remaining in
the battery
Ȳ After 20 seconds, the lights will switch off
Please Note
a. The power bank will generate heat when charging.
Always charge in a well ventilated area. Do not charge
under pillows, blankets or on ammable surfaces.
b. Keep the power bank away from heat sources, direct
sunlight, combustible gas, humidity, water or other liquids
c. Do not disassemble, open, microwave, incinerate, paint or
insert foreign objects into the power bank
d. Do not subject the power bank to mechanical shock such
as crushing, bending, puncturing, or shredding. Avoid
dropping or placing heavy objects on the power bank.
e. Do not short-circuit the power bank or store it in a
receptacle where it may be short-circuited by other
metallic or conductive objects
f. Do not operate the power bank if it has been wet or
otherwise damaged, to prevent against electric shock,
explosion, and/or injury. Contact the dealer or
authorized agent.
Ȳ Do not remove the wireless charging plate for the battery.
If the plate is bent or exed it can break.
Ȳ Do not store device in high-temperature environment,
including heat caused by intense sunlight or other forms
of heat. Do not place device in for or other excessively
hot environments.
Ȳ Do not disassemble this device or attempt to re-purpose
or modify it in any manner
Ȳ For instructions or questions about the various ways to
change this device, refer to the illustrations in this
quick-start guide
Ȳ Do not attempt to replace any part of this device
Ȳ All products have gone through a thorough quality
assurance inspection. If you nd that your device is
excessively hot, is emitting odour, is deformed, abraded,
cut or is experiencing or demonstrating an abnormal
phenomenon, immediately stop all product use and
contact manufacturer.
Legal
This product is meant for use only in conjunction with the
appropriate device. Please consult your device packaging
to determine whether this product is compatible with your
particular device. Manufacturer is not responsible for any
damages to any device incurred through the use of
this product.
Manufacturer shall not in any way be liable to you or to
any third party for any damages you or any third party may
suffer as a result of use, intended or unintended, or misuse
of this product in conjunction with any device or accessory
other than the appropriate device for which this product
is designed. Manufacturer will not be responsible for any
damages you or any third party may suffer as a result of
misuse of this product as outlined above.
If you are responsible for product use with an unintended
device and damages result from such use, you agree to
indemnify Manufacturer for any resulting injuries to any
third party(ies).
FCC Statement
DECLARATION OF CONFORMITY WITH FCC RULES FOR
ELECTROMAGNETIC COMPATIBILITY
We, Nolii Ltd of 151 Wardour St, Soho, London W1F 8WE,
declare under our sole responsibility that the products M19.
C1.C4.2Z, M19.C6.C4.2Z, M19.C3.C5.2Z to which this
declaration relates, comply with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) including
interference that may cause undesired operation.
Page 5
Federal Communications Commission Notice
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one of the following measures:
Ȳ Reorient or relocate the receiving antenna
Ȳ Increase the distance between the equipment and
the receiver
Ȳ Connect the equipment to an outlet on a circuit different
from that to which the receiver is connected
Ȳ Consult the dealer or an experienced radio/TV technician
for help
FCC Caution: Any changes or modications not expressly
approved by the party responsible for compliance could void
the user’s authority to operate this equipment.
CE Declaration of Conformity
We, Nolii Ltd declare under our sole responsibility that
the product model M19.C1.C4.2Z, M19.C6.C4.2Z, M19.
C3.C5.2Z, to which this declaration relates, is in conformity
with EMC Directive 2014/30/EU, Low Voltage Directive
2014/35/EU & RoHS Directive 2011/65/EU (Recast).
We further declare that the product meets the essential
requirement of the above Directives. The limits contaied in
these articles are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of
the following measures:
Ȳ Reorient or relocate the receiving antenna
Ȳ Increase the separation between the equipment
and receiver
Ȳ Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected
Ȳ Consult the dealer or an experienced radio/TV technician
for help
Caution: Any changes or modication not expressly approved
by the party responsible for compliance could void the user’s
authority to operate this equipment.
A copy of the European Union CE marking ‘’Declaration of
Conformity’’ may be obtained at the website:
www.wearenolii.com
For information on product disposal please refer to
www.wearenolii.com
Page 6
Designed for Life
Loading...