EN
USER INSTRUCTIONS AND SAFETY
Firmware Version: 3.1x
Congratulations on your purchase of an N-Com product.
N-
Com
B X4 was made using the most advanced technologies and the
best materials. Long-running tests and thorough system development
have allowed the highest audio quality to be achieved.
For additional information about B X 4 , and to download highÂinstructions as well as the latest
www.n-com.it
REFERENCE STANDARDS
The products of the N-Com line are in compliance with standards as per the table
below:
B X 4
Battery
charger
Battery
The Declarations of Compliance can be downloaded from the website www.n
com.it
(Download section).
The Bluetooth system complies with the main safety
requirements and other applicable provisions of Directive
99/5/CE
Directive 2006/95, 2004/108, 2002/95/CE, 2002/96/CE,
2009/125/CE
Directive 2006/66
, Dir
ective 2002/95/CE, Directive 2002/96/CE
Firmware
version, visit the website
definition
-
FccID: XXXXXXXXX
Bluetooth is a registered trademark property of Bluetooth SIG, Inc.
XXXXX
FOR USA MARKET ONLY: SPECIAL WARNING
This device complies with part 15 of the FCC and Industry Canada Rules.
Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user s authority to operate the equipment.
NOTE: The manufacturer is not responsible for any radio or TV interference
caused by unauthorized modifications to this equipment. Such modifications
cou
ld void the user s authority to operate the equipment.
This product has been tested and complies with the specifications for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used according to the instructions, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which is found by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment or devices
Connect the equipment to an outlet other than the receiver s
Consult a dealer or an experienced
radio/TV technician for assistance
B x 4
FccID: XXXXXXXXX
Bluetooth is a registered trademark property of Bluetooth SIG, Inc.
XXXXX
3
Loading...