Nolangroup S p A NCOM5 User Manual

Firmware Version: 1

USER INSTRUCTIONS AND SAFETY

Congratulations on your purchase of an N-Com product. N-

Com B1 was made using the most advanced technologies and the best materials. Long-running tests and thorough system development have allowed the highest audio quality to be achieved.

For additional information about definition instructions as well as the latest the website

REFERENCE STANDARDS

The products of the N-Com line are in compliance with standards as per the table below:

The Bluetooth system complies with the main safety

Battery charger

, and to download high-

Firmware

www.n-com.it

requirements and other applicable provisions of Directive 99/5/CE

Directive 2009/125/CE

, Directive 2002/95/CE

, Directive

2006/95, 2004/108, 2002/95/CE, 2002/96/CE

2002/96/CE

version, visit

Battery

The Declarations of Compliance can be downloaded from the website c

om.it

Bluetooth is a registered trademark property of Bluetooth SIG, Inc.

(Download section).

FccID: Y6MNCOM5

Directive

2006/66

N21550

www.n

Contents

1. WARNINGS AND SAFETY

1.1.

Road safety

1.2.

Switching on the system in safe environments

1.3.

Interferences

1.4.

Appropriate use

1.5.

Qualified personnel

1.6.

Accessories and batteries

1.7.

Disposal

2. CONTENT OF THE PACKAGING

3. INSTALLATION

3.1.

Installing the microphone

3.2.

Connecting the battery

3.3.

Installing the system on the helmet

4. REMOVING THE SYSTEM

5. SYSTEM

5.1.

Basic functions

5.2.N-

Com Wizard

6. PAIRING UP BLUETOOTH DEVICES

6.1.

Affiliation reset function

7. MOBILE PHONE FUNCTIONS

8. GPS SATELLITE NAVIGATOR FUNCTIONS

9. BLUETOOTH A2DP MUSIC PLAYER

10. AUDIO DEVICES

11. RIDER-PASSENGER INTERCOM MODE

11.1.

Intercom affiliation

11.2.

Intercom function

12. BATTERY

12.1.

Battery discharged signal

12.2.

Recharging the system

13. SUMMARY TABLE OF CONTROLS

14. LIMITED WARRANTY

14.1.

Warranty coverage

14.2.

Exclusions and limitations of the coverage

14.3.

Validity of this limited warranty

14.4.

Procedure for the forwarding of claims

14.5.

Product identif

15. WARRANTY REGISTRATION FORM

...........................................................................

.........................................................................

.....................................................................

................................................................

................................................................................

.......................................................................

CHARACTERISTICS

......................................................................15

WITH CABLE CONNECTION

................................................................18

..............................................................................

ication

........................................................

................................................

........................................................

...........................................................10

.........................................11

.......................................................

.................................................

.........................................................16

.................................................

........................................

..............................................................18

......................................................19

.........................................................19

...........................................

............................................................

..............................................................21

.............................................21

...........................................................22

............................

.......................................

.............................

........................

..................................18

...............................21

....................................22

.......................................

. 5

14 14

16 16 17 17

20 21

4 4 4 4

5 6

6 7

1. WARNINGS AND SAFETY

Read this User Manual carefully, as well as the User Manuals for other N-Com kits that you will be using with the N-Com B1. Read the simple rules listed below. Failure to comply with these rules may lead to dangerous situations.

Caution

Warning

1.1.

Always obey all Traffic Regulations in force. While riding the motorcycle, your hands should always be engaged in actually riding the vehicle. Any operation to the N-Com system must be car

1.2.

: The product cannot be used in official or non-official competitions, motordromes,

circuits, racing tracks an

: Installation of the Napproximately accessories.

: The electronic components of the N-Com system mounted inside th not waterproof. Consequently, make sure the inside of the helmet, including the comfort padding, does not get wet in order to avoid damage to the system. If it does, remove the N-Com system and the helmet comfort padding and let it air dry. Di

sconnect the battery connector and let it dry as well.

Road safety

ried out with the vehicle stopped. Set your cell phone on automatic answer (see the cell phone instructions to do this). If your cell phone is not equipped with this function, first stop your vehicle in a safe area, in compliance with Traffic Do not make any calls while riding. Stop your vehicle in a safe place in compliance with Traffic Regulations, and then make the call. Adjust the volume so that it does not cause a disturbance or distraction while ridi and at the same time allows you to distinctively hear background noises. Do not operate your cell phone or other devices connected to N-Com while riding your motorcycle. In all cases, obey the Traffic Regulations and remember that riding the motorcycle has absolute priority over any other maneuver.

Switching on the system in safe environments

When using the N-Com system, comply with all limitations and instructions related to the use of cell phones. Do not turn on your cell phone or the N-Com system whenever their use is forbidden or when the devices can cause interference or dangerous situations. Turn off while refueling. Do not use the N-Com system in filling stations. Do not use the device near combustible materials or chemical products. Turn off in

110

proximity to explosive materials.

d the like.

g, which is added to the weight of the helmet and of the other

Com B1 system results in a weight increase of

e helmet are

Specifically:

Regulations and then answer the call.

1.3.

Interferences

All phones and devices with wireless signal transmission are subject to interferences that may affect the performance of the device connected to them. These interferences are not ascribable to a defect of th

1.4.

Appropriate use

Use the device only in the normal position, as described in the product documentation. Do not attempt to disassemble, tamper with or modify any part of the N-Com system.

e N-Com system.

Caution

: Adjust the volume of the N-Com system (where provided) and of the audio

sources connected to it before you use the system on the road.

Caution

Warning:

1.5.

1.6.

: Adjusting the volume to very high levels may cause damage to your hearing.

: Adjust the volume of the N-Com system (where provided) and of the audio sources connected to it so as to avoid audio reproduction at high volumes. Constant exposure to high audio volumes may damage your hearing.

: An incorrect installation of the system in the helmet may alter the aerodynamic and safety characteristics of the helmet itself, thus creating dangerous conditions. Install the N-Com system according to the instructions provided in the product documentation. In case of doubt, please contact your local N-Com dealer.

Listening to other equipment sh must be the top priority at all times. Carry out all operations on the electronic equipment and on the N-Com system with the vehicle stopped, in compliance with Traffic Regulations.

Qualified personnel

Only qualified personnel can carry out technical assistance on this product. In case of any malfunction, always turn to your local dealer. The helmet is a safety device. Tampering with it and/or with the electronic system inside the helmet, in addition to invalidating the product warranty, can also lead to dangerous situations.

Accessories and batteries

Only use the type of batteries, battery chargers and accessories approved by Nolan for the specific model. The use of a battery type different from the recommended one may lead to dangerous situations and invalidate the warranty. Contact your local dealer to see about the availability of approved accessories. When disconnecting the power supply cable of any accessory or of the battery charger, always grab an Do not use batteries for purposes other than the prescribed ones. Never use batteries or battery chargers that turn out to be damaged. Do not short-circuit the battery. Keep the battery at a temperature between 0 ° / + 45°C (charging

°C

(in use).

Danger of fire or explosion: do not throw the batteries into a fire nor expose them to high temperatures! Do not throw out batteries together with household refuse. The batteries should be disposed of in compliance with lo Do not wear the helmet while the battery is recharging. The helmet should never be left within the reach of unsupervised children in order to prevent damage to their health caused by access to the batteries.

d pull the plug not the cable.

ould not interfere with driving the vehicle, which

cal regulations

) ; -20° / + 60

Battery Batterycharger

Lithium Ion593847 AK00G-0500040VU S-TR-

038

3,7V

800mAh 100/240v 100-240V - 60/50Hz 0.1A

50/60 Hz 5V

0,4 A

1.7.

Disposal

Refer to this user manual and to manuals related to other parts of the N-Com system in order to disassemble the system from the helmet. Once the system has been disassembled, dispose of it according to the following instructions:

The proper disposal of obsolete equipment contributes to preventing possible negative consequences on people s health and on the environment.

For more detailed information on the disposal of obsolete equipment, contact your municipality, a waste disposal service or the store where the product was purchased.

The presence of a crossed-out wheelie bin indicates that in the European Union the product is subject to separate collection at the end of its useful life (Eur Do not dispose of these products together with undifferentiated urban waste.

opean Directive 2002/96/EC).

2. CONTENT OF THE PACKA

The N-Com B1 package contains:

box B1

icrophone

GING

Electronic plate

Rechargeable battery

connection cable

Battery charger

Battery holder

Key and screw

Clamp

Microphone

Stop

Adhesive

Velcro pads

et shell (Fig. 1)

3. INSTALLATION

Fig. 1

Fig. 3

Fig. 2

Remove the N-Com protection plate located on the helm and open the helmet chin guard (flip up helmets).

Remove the right and left cheek pads from the helmet (see specific instructions provided in the user manual of the helmet).

Remove the Noise Reducers from the two cheek pads, and tear off the precut plastic (if equipped).

Fig. 4

Fig. 6

Fig. 5

Remove the back of the comfort

padding by pulling on the neck roll until it separates from the shell (Fig.

4).

Temporarily put the padding on the

outside of the helmet (Fig. 5).

Remove the N-Com cover from the

helmet border gasket. Push from the inside of the helmet to facilitate the removal (Fig. 6).

Fig. 7

ONLY FOR FULL-FACE HELMETS

Remove the chin guard by pulling on

the special red tab.

Fig. 8

Remove the right and left polystyren

cheek pads by gently pulling them out of the helmet. The helmet shell can be opened slightly to facilitate the removal of the cheek pad

Caution

: In case the polystyrene cheek pad is damaged during this operation, turn to your local dealer for its repl

acement.

+ 16 hidden pages

Nolangroup S p A NCOM5 User Manual

Specifications and Main Features

Frequently Asked Questions

User Manual