Nolangroup S p A NCOM11 Users manual
Firmware Version: 5.0x
EN
USER INSTRUCTIONS AND SAFETY
Congratulations on your purchase of an N-Com product.
N-Com M5 was made using the most advanced technologies and the best
materials. Long-running tests and thorough system development have allowed the
highest audio quality to be achieved.
For additional information about M5 visit the website www.n-com.it
REFERENCE STANDARDS
The products of the N-Com line are in compliance with standards as per the table below:
The Bluetooth system complies with the main safety requirements and
M5
Battery
charger
Battery Directive 2006/66
The Declarations of Compliance can be downloaded from the website www.n-com.it
(Download section).
other applicable provisions of Directive 99/5/CE, Directive 2002/95/CE,
Directive 2011/65/CE, Directive 2002/96/CE
Directive 2006/95, 2004/108, 2002/95/CE, 2011/65/CE, 2002/96/CE,
2009/125/CE
FccID: XXXXXX
Bluetooth is a registered trademark property of Bluetooth SIG, Inc.
N21550
Sommario
1. WARNINGS AND SAFETY.................................................................................................4
1.1.Road safety ................................................................................................................................................................4
1.2.Switching on the system in safe environments .........................................................................................4
1.3.Interferences..............................................................................................................................................................4
1.4.Appropriate use .......................................................................................................................................................4
1.5.Qualified personnel ................................................................................................................................................5
1.6.Accessories and batteries....................................................................................................................................5
1.7. Disposal.....................................................................................................................................................................6
2. INSTALLATION....................................................................................................................6
2.1.Positioning the speakers and the microphone..........................................................................................6
2.2.E-box installation.....................................................................................................................................................6
2.3.Positioning the wireless keypad.......................................................................................................................7
3. BASIC FUNCTIONS............................................................................................................. 7
3.1.N-Com Wizard..........................................................................................................................................................7
3.2.N-Com App................................................................................................................................................................8
3.3.Pairing up Bluetooth devices.............................................................................................................................8
4. MOBILE PHONE..................................................................................................................8
4.1.Double bluetooth device management........................................................................................................ 9
5. Music via Bluetooth – A2DP Bluetooth Protocol......................................................... 9
6. Music via caBLE...................................................................................................................9
7. BIKE SATELLITE NAVIGATOR............................................................................................9
8. FM RADIO..........................................................................................................................10
9. RIDER-PasseNGER INTERCOM......................................................................................10
9.1.Rider-Passenger intercom pair up.................................................................................................................10
9.2.Rider-Passenger intercom function ..............................................................................................................10
10. BIKE TO BIKE INTERCOM................................................................................................10
10.1.Bike to Bike intercom pair up........................................................................................................................11
10.2.Bike to Bike intercom function .....................................................................................................................11
10.3.Helmet connection/disconnection .............................................................................................................11
11. Setting ................................................................................................................................12
12. Auto On / Off....................................................................................................................12
13. BATTERY.............................................................................................................................12
13.1.Battery discharged signal................................................................................................................................12
13.2.Recharging the system.....................................................................................................................................12
14. LIMITED WARRANTY.......................................................................................................13
14.1.Warranty coverage.............................................................................................................................................13
14.2.Exclusions and limitations of the coverage ............................................................................................13
14.3.Validity of this limited warranty ...................................................................................................................14
14.4.Procedure for the forwarding of claims ...................................................................................................14
14.5.Product identification .......................................................................................................................................15
15. WARRANTY REGISTRATION FORM..............................................................................16
M5
3
1. WARNINGS AND SAFETY
Read this User Manual carefully, as well as the User Manuals for other N-Com kits that you will be using
with the N-Com M5. Read the simple rules listed below. Failure to comply with these rules may lead to
dangerous situations.
Caution: The product cannot be used in official or non-official competitions, motordromes, circuits,
racing tracks and the like.
Caution: Installation of the N-Com M5 system results in a weight increase of approximately 110g, which
is added to the weight of the helmet and of the other accessories.
Warning: The electronic components of the N-Com system mounted inside the helmet are not
waterproof. Consequently, make sure the inside of the helmet, including the comfort padding, does
not get wet in order to avoid damage to the system. If it does, remove the N-Com system and the
helmet comfort padding and let it air dry. Disconnect the battery connector and let it dry as well.
1.1. Road safety
Always obey all Traffic Regulations in force. While riding the motorcycle, your hands should always be
engaged in actually riding the vehicle. Any operation to the N-Com system must be carried out with the
vehicle stopped. Specifically:
Set your cell phone on automatic answer (see the cell phone instructions to do this).
If your cell phone is not equipped with this function, first stop your vehicle in a safe area, in
compliance with Traffic Regulations and then answer the call.
Do not make any calls while riding. Stop your vehicle in a safe place in compliance with Traffic
Regulations, and then make the call.
Adjust the volume so that it does not cause a disturbance or distraction while riding and at the
same time allows you to distinctively hear background noises.
Do not operate your cell phone or other devices connected to N-Com while riding your
motorcycle.
In all cases, obey the Traffic Regulations and remember that riding the motorcycle has absolute
priority over any other maneuver.
1.2. Switching on the system in safe environments
When using the N-Com system, comply with all limitations and instructions related to the use of
cell phones.
Do not turn on your cell phone or the N-Com system whenever their use is forbidden or when the
devices can cause interference or dangerous situations.
Turn off while refueling. Do not use the N-Com system in filling stations. Do not use the device
near combustible materials or chemical products.
Turn off in proximity to explosive materials.
1.3. Interferences
All phones and devices with wireless signal transmission are subject to interferences that may affect the
performance of the device connected to them. These interferences are not ascribable to a defect of the
N-Com system.
1.4. Appropriate use
Use the device only in the normal position, as described in the product documentation. Do not attempt
to disassemble, tamper with or modify any part of the N-Com system.
4
Caution: Adjust the volume of the N-Com system (where provided) and of the audio sources connected
to it before you use the system on the road.
Caution: Adjusting the volume to very high levels may cause damage to your hearing.
Caution: Adjust the volume of the N-Com system (where provided) and of the audio sources connected
to it so as to avoid audio reproduction at high volumes. Constant exposure to high audio volumes
may damage your hearing.
Caution: An incorrect installation of the system in the helmet may alter the aerodynamic and safety
characteristics of the helmet itself, thus creating dangerous conditions. Install the N-Com system
according to the instructions provided in the product documentation. In case of doubt, please
contact your local N-Com dealer.
Warning: Listening to other equipment should not interfere with driving the vehicle, which must be the
top priority at all times. Carry out all operations on the electronic equipment and on the N-Com
system with the vehicle stopped, in compliance with Traffic Regulations.
Caution: M5 allows radio reception. Any radio licence fees are to the user’s charge.
M5
1.5. Qualified personnel
Only qualified personnel can carry out technical assistance on this product. In case of any
malfunction, always turn to your local dealer.
The helmet is a safety device. Tampering with it and/or with the electronic system inside the
helmet, in addition to invalidating the product warranty, can also lead to dangerous situations.
1.6. Accessories and batteries
Only use the type of batteries, battery chargers and accessories approved by Nolan for the specific
model.
The use of a battery type different from the recommended one may lead to dangerous situations
and invalidate the warranty.
Contact your local dealer to see about the availability of approved accessories.
When disconnecting the power supply cable of any accessory or of the battery charger, always
grab and pull the plug not the cable.
Do not use batteries for purposes other than the prescribed ones.
Never use batteries or battery chargers that turn out to be damaged.
Do not short-circuit the battery.
Keep the battery at a temperature between 0° / +45°C (charging); -20° / +60 °C (in use).
Danger of fire or explosion: do not throw the batteries into a fire nor expose them to high
temperatures!
Do not throw out batteries together with household refuse. The batteries should be disposed of in
compliance with local regulations
Do not wear the helmet while the battery is recharging.
The helmet should never be left within the reach of unsupervised children in order to prevent
damage to their health caused by access to the batteries.
Battery LI-Pol 562547 3.7 V – 600 MAH
Battery charger FY0901000 100/240v – 50/60 Hz
5
1.7. Disposal
Refer to this user manual and to manuals related to other parts of the N-Com system in order to
disassemble the system from the helmet. Once the system has been disassembled, dispose of it
according to the following instructions:
The proper disposal of obsolete equipment contributes to preventing possible negative
consequences on people’s health and on the environment.
For more detailed information on the disposal of obsolete equipment, contact your municipality, a
waste disposal service or the store where the product was purchased.
The presence of a crossed-out wheelie bin indicates that in the European Union the
product is subject to separate collection at the end of its useful life (European
Directive 2002/96/EC).
Do not dispose of these products together with undifferentiated urban waste.
2. INSTALLATION
2.1. Positioning the speakers and the microphone
Remove the adhesive film from the Velcro of the speakers;
Position the speakers so that they stick perfectly to the cheek pad.
N.B.: If possible, position the speakers underneath the comfort padding of the helmet.
The microphone can be fixed onto the helmet in two ways:
Boom Microphone:
Place the section with the Velcro/adhesive strip between the padding and the rigid cover of
the helmet, so that the microphone is correctly positioned in front of your mouth.
N.B.: This type of microphone is suited for Open Faced and Flip Front helmets.
Caution: make sure that the side of the microphone support with the writing “N-Com” is facing inward.
Wired microphone
Using the Velcro/adhesive strip, place the microphone inside the helmet in front of your mouth.
N.B.: This type of microphone is more suited for Full Faced helmets.
Connect the microphone with its counterpart on the wire assembly
Extract the e-box connector from the backside of the helmet, ready to be connected with the e-
box
2.2. E-box installation
The e-box must be placed on the back side of the helmet, using the adhesive feet
Clean the helmet surface where the adhesive feet will be positioned.
Connect the connector to the e-box
Insert the adhesive feet on the device and verify the correct positioning of the e-box on the
helmet. If necessary, depending from the shape of the helmet, substitute one or more
adhesive feet with high type until you find the best combination in order to assure the correct
adhesion of the ebox.
Remove the protective film from the feet and apply the system to the helmet;
N.B.: In case the adhesive plate is not in the right position, peel it off immediately from the
helmet and repeat the positioning.
6
Loading...