Socket 1366 Mounting-Kit | Installation Manual
Thank you very much for choosing a Noctua cooler for your
socket 1366 system.
The SecuFirm2™ Mounting-Kit for socket 1366 is compatible
with the following CPU coolers: NH-C12P, NH-U12F, NH-U12P,
NH-U9B, NH-U9F, NH-U12, NH-U9.
This manual will guide you through the installation process
step by step using an NH-U12P heatsink as an example.
Please note that the installation procedure is identical for all
models.
Should you encounter any difficulties, please check the FAQs
on our website and don’t hesitate to contact our support team
at support@noctua.at.
Noctua cannot be held responsible for any damage or losses
caused by compatibility issues.
Multilingual versions of this manual are available on our
website: www.noctua.at
Required mounting parts:
Step 4:
Attaching the fastening brackets to the heatsink
Tightly screw the fastening brackets to the base of the heatsink
using 4 short screws.
Step 3:
Installing the mounting bars
First put the spacers onto the screw sockets of the backplate.
Then fix the mounting bars using the 4 thumb screws.
Step 5:
Applying thermal paste
If there are residual traces of thermal paste or thermal pads
on your CPU, please clean them off first. Then press a small
drop (4-5mm diameter) of NT-H1 onto the centre of the heatspreader.
1x socket 1366 backplate
2x mounting bars
4x thumbscrews 4x short screws
Step 1:
2x fastening brackets
4x plastic spacers
Removing the mainboard
In case you want to use the cooler on an assembled system,
you first have to remove the mainboard from the case as the
cooler has to be screwed to the backplate on the back of the
mainboard.
Choose the alignment of the mounting bars according to the
desired final orientation of the cooler:
Orientation A Orientation B
Caution: Make sure that the curved sides of the mounting
bars are pointing outwards.
Caution: Applying too much thermal paste will lower the heat
conductivity and cooling performance!
Step 6:
Fastening the heatsink to the CPU
Caution: If you are using the cooler for the first time, please take
off the protection cover at the bottom side of the heatsink first!
Put the heatsink onto the CPU and screw it to the screw threads
of the mounting bars.
Caution: Tighten the screws until they stop.
Step 2:
Attaching the backplate
Place the backplate on the back side of the mainboard so that
the screw threads stick through the mounting holes.
Step 7:
Installing the fan
Install the fan as described in the manual that came with the
cooler.
Loading...