Page 1
[1] NM Carbon Lip Spoiler
[9] M6 Lock Nuts
[9] M6x16mm Screws
[18] M6 Washers
[1] Masking/Painters Tape
[1] Electric Drill
[1] 4mm Hex Key Wrench
[1] Flat Screw Driver
[2] Clamps (optional)
[1] 1/4” Drill Bit
[1] 10mm Wrench
[1] Phillip Screw Driver
CARBON FIBER FRONT LIP SPOILER – NM.958855
2008–10 [R55] MINI Cooper S Clubman & JCW (without JCW Aero Kit)
2007–10 [R56] MINI Cooper S Hardtop & JCW (without JCW Aero Kit)
2009–10 [R57] MINI Cooper S Convertible & JCW (without JCW Aero Kit)
PARTS INCLUDED:
TOOLS & SUPPLIES REQUIRED:
1. On bottom side of front bumper cap remove the five plastic
fasteners.
3. Mark the lower bumper for the (9) mounting holes using the
Lip Spoiler as template.
4. Remove Lip Spoiler and proceed to drilling using 1/4” bit.
2. Position and align Lip Spoiler on bumper making sure the two
surfaces are seated properly securing with tape or clamps or
both.
5. Secure Lip Spoiler using the supplied hardware using 4mm
Hex Key wrench and 10mm wrench. Pull down factory lower
valance to gain more clearance for inserting nut and washer.
Do not over tighten since it will cause damage to carbon fiber
surface.
6. Reinstall underside bumper cap fasteners.
©2011 NM Engineering, a division of Automotive Performance Systems, Inc.
All rights reserved. Reproduction in whole or in part is prohibited.
DOC. NM.958855 Rev. 11.09.11
NM Engineering ∞ 3300 Corte Malpaso, Camarillo, CA 93012 ∞ 805.388.7171 ∞ 805.388.0030 FAX
engineer@nm-eng.com ∞ www.nm-eng.com
Loading...