Page 1
NM Engineering ∞ 3300 Corte Malpaso, Camarillo, CA 93012 ∞ 805.388.7171 ∞ 805.388.0030 FAX
engineer@nm-eng.com ∞ www.nm-eng.com!
!
!
PARTS INCLUDED: TOOLS REQUIRED:
[2] NM Urethane Inserts [1] Torque Wrench [1] Ratchet Wrench [1] 16mm Socket
[1] Jack [2] Jack Stands [1] 18mm Socket
1. Park car on a flat and level surface capable of supporting
the vehicle’s weight on vehicle jack and jack stands.
Using the manufacturer recommended lifting points, raise
the front of vehicle and support with jack stands under
lifting points. NEVER WORK ON A VEHICLE
SUPPORTED ONLY WITH A JACK!
2. Underneath the vehicle: Remove the 16mm and 18mm
hex bolts to remove engine torque arm from sub-frame.
3. Pull down front of torque arm out of mount, push engine
forward then rotate toward transmission and pull out
from sub-frame.
4. Install NM Engine Torque Arm Inserts into each side of
OE torque arm. Note: Arrow in urethane faces toward
front of vehicle. Red urethane used for picture clarity.
5. Install in reverse of disassembly. Torque bolts 80 ft.-lbs.
ENGINE TORQUE ARM INSERT – NM.228860
[R60] MINI Countryman AWD only 2011-up
!
©2011 NM Engineering, a division of Automotive Performance Systems, Inc.
All rights reserved. Reproduction in whole or in part is prohibited.
Loading...