Nitrous Express Speed3000 R/C Vehicle Nitrous System
Installation Instructions
The nitrous bottle is shipped empty and must be filled before the system can be used. The
bottle capacity is 4oz
Removal of the body and partial disassembly of your r/c vehicle may be necessary to access all
electronics and to complete the nitrous installation.
1. Find the best and most secure location for the 9v battery to be mounted. This
location needs to be easily accessible, yet protected from possible damage while you
are operating the vehicle.
2. Turn on your transmitter and your receiver and then go to full throttle. Place the
micro switch so that the servo arm activates the micro switch. Mark this location,
then drill and mount the micro switch.
3. Now you will need to choose a location for a master arming switch. This can be
anywhere that is easily accessible and so that it does not interfere with any
mechanical linkages
4. Install the .009 jet into the push-to-connect jet fitting and thread into solenoid
outlet port. Tighten snugly, but do not over tighten. Install the 3an Swivel fitting
into the inlet port of the solenoid. This will allow for mounting the nitrous solenoid
directly to the bottle valve.
5. Mount the nitrous bottle using the supplied hardware. Be sure the bottle does not
interfere with any mechanical linkages.
6. Install the 1/8 poly line into the push-to-connect fitting previously installed in the
nitrous solenoid outlet port and route the line into the air filter. The hose should
discharge toward the air filter but should not be inserted directly into it. Secure the
line with zip ties.
7. Follow the wiring diagram below, solder and wrap all connections with heat shrink
to complete the install. The nitrous solenoid in this system is DC, so any wire can be
chosen as power or ground wire.
8. Once all connections are secured, test the system by arming the master arming
switch and activating the throttle servo until wide-open throttle is achieved, the
nitrous solenoid should click as the throttle linkage causes the micro switch to be
engaged.
9. Once all steps are completed be sure all fittings, nuts and bolts are tight. Re-install
any covers or clips that were removed during the installation process.
10. After we have assured the system is functioning properly it is time to open the
previously filled bottle and have some fun!
Loading...