Nitek WB5326 User Manual

WB5326

Wireless Bridge

Quick Start Guide

01/09/12

Quick Start Guide

WB5326 Outdoor Wireless Bridge

Items Included in Kit

(1) WB5326 RADIO
(1) PoE (48V, 1A)
(1) Mounting Hardware Accessories
(1) Quick Start Guide
(1) Product CD

Hardware Installation

1. Put an Ethernet cable with RJ-45 connector through the water-tight joint. Make the RJ-45 connector as a 568B
wiring configuration:

2. Using the hardware provided mount the Bridge unit in position. Make sure that the Ethernet connection is

3. Plug water-tight joint side of the Ethernet cable into the Bridge unit. Connect the other end of the cable to the

4. There is a ground connection on the Bridge unit located near the antenna port. The ground connection should

5. The antenna of the Bridge unit is behind the plastic face of the unit and must face the other Bridge unit. Make

6. Power the unit using the supplied PoE inserter.

Terminal Wire

1 Orange/White
2 Orange
3 Green/White
4 Blue
5 Blue/White
6 Green
7 Brown/White
8 Brown

facing down. Keep in mind that the unit has a built-in antenna and must have line of sight between units. Refer
to separate mounting guide sheet for illustrations of hardware assembly.

power injector supplied with the unit. Also connect a standard RJ-45 network cable for the power injector to a
hub or a terminal.

be connected to a proper earth ground point.

sure you have line of site to the opposite unit and that they face each other.

3

14

2

12345678

568B

Warning Do not mount Bridge unit near electric power lines, electric
lights or near strong electric power signals

2