![](/html/78/78b2/78b27156f41263b3e7a6a05fa1b8163ecc9c1222075fbf9f0be3408e8bbc24af/bg1.png)
Installation and
Operation Manual
TS560 &
TR560
NITEK
5410 Newport Dr., Suite #24 • Rolling Meadows, IL 60008
PHONE (847) 259-8900 • FAX (847) 259-1300
Internet: www.nitek.net • E-mail: INFO@nitek.net
®
Rev 101903
![](/html/78/78b2/78b27156f41263b3e7a6a05fa1b8163ecc9c1222075fbf9f0be3408e8bbc24af/bg2.png)
TABLE OF CONTENTS
Page
Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
System Specifications. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Installation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-4
Troubleshooting. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Twisted Sender Warranty. . . . . . . . . . . . . . . . . . . . . . . . . . 5
Twisted Sender Transmitter Diagram. . . . . . . . . . . . . . . . . 6
Twisted Sender Receiver Diagram. . . . . . . . . . . . . . . . . . . 6
Reduce risk of fire or electrical shock do
not expose this product to rain or moisture.
![](/html/78/78b2/78b27156f41263b3e7a6a05fa1b8163ecc9c1222075fbf9f0be3408e8bbc24af/bg3.png)
Introduction
Twisted Sender has been designed by NITEK to transmit
video signals over a point to point pair of wires. The wire should
be free of voltage or other outside signals. Twisted Sender
can turn your in-house phone lines, leased telephone lines or
cable runs into pathways for video signals. Twisted Sender
is ideal for shopping malls, parking garages, remote gates,
large factories, airports or any number of places where you
need to connect video equipment.
Features of the TS560 and TR560
❒ Live video over twisted pair lines for up to 3,000 feet
❒ L ive video up to 6,000 feet when used with the TT560
❒ Easy to install with just a screwdriver
❒ High resolution color or monochrome video
❒ Low power consumption, less than 1 watt for receiver
❒ Virtually impervious to hum and noise
❒ No power required for the transmitter
Page 1