Nitek CXM22 User Manual

Model CHM22
4 Channel Crossover, Power Insertion,
Installation and
Operation Manual
Data Distribution and Video Card
Model CXM22
4 Channel Crossover, Power Insertion, Data Distribution Card
If using CHM22 Cards
When using the CHM22 card the video for each camera is provided out the front of the card on BNC jacks. Connections for the camera port are shown below in the chart labeled CAMERA PORT. Video from the BNC can be fed into other equipment as needed. Control data for a PTZ camera can be connected to the 2 pin jack on the rear of the CX452 or CX254.
CAMERA PORT
Power
+
8
Power
-
7
Power
+
6
Data
+
5
Data
-
4
Power
-
3
Video
-
2
Video
+
1
3
14
2
12345678
568B
VIDEO PORT
-
8
Vid 4
+
7
Vid 4
-
6
Vid 3
+
5
Vid 1
-
4
Vid 1
+
3
Vid 3
-
2
Vid 2
+
1
Vid 2
If using CXM22 Cards
The CXM22 card has four camera ports on the front of it. Connections for the camera ports are shown above in the chart labeled CAMERA PORT. All RJ45 jacks are wired to the T568B standard. Video from each of the four camera ports is routed to a single RJ45 jack on the rear of the CX452 or CX254 unit. Each card has its own RJ45 jack and connections are shown in the chart above labeled VIDEO PORT. Using a standard RJ45 cable you can then route the video signals to the copper backbone of the facility. Control data for a PTZ camera can be connected using the 2 pin jack on the rear of the CX452 or CX254.
Adjusting Camera Output Voltage (CHM22 & CXM22)
Camera output voltage can be adjusted by moving the voltage jumpers which are located in the middle of the circuit board. Three options are available: 28VAC, 24VAC, or no voltage output.
(CHM22 card shown)
USA Office: 5410 Newport Drive, Rolling Meadows, IL 60008 Phone: (800) 528-4343 Fax: (847) 259-1300 E-mail: info@nitek.net WWW.NITEK.NET
681630113
NITEK®
Move jumper back for 24VAC
Move jumper forward for 29VAC
Remove jumper for no voltage
Europe Office: De Schans 19-21 2a, 8231 KA Lelystad The Netherlands Tel: +31(0)320-2300005 Fax: +31(0)320-282186 E-mail: info@nitek.nl WWW.NITEK.NL
Loading...