Nissan 2006 titan Instructions Manual

THIS KIT INCLUDES:

 8 M8-1.25X30MM BOLTS

WITH WASHERS

 RIGHT AND LEFT HINGE

ASSEMBLY

 2 SHOULDER BOLTS WITH

WASHERS

 2 SHOCKS 705 PSI

 2 PINS  8 NUTS WITH WASHERS

TOOLS REQUIRED FOR INSTALLATION:

 AIR RACHET, GRINDER AND

CUTTER.

 7MM, 8MM,10MM, 11MM,

13MM, SOCKETS AND
EXTENSION.

 FORK AND PHILLIP’S SCREW

DRIVERS

 SPACERS FOR THE DOOR

GAP.

 3/16 ALLEN WRENCH

 1/4 TORX BIT

 9/16 WRENCH

 LOCKTITE RED

OTHER TOOLS MAY BE NEEDED DEPENDING ON YOUR VEHICLE.

“Installers with experience recommended”

(Note: The pictures on the manual are for reference only

they may not match your vehicle.)

1) Disconnect the battery.

2) Remove fender:

Remove all the screws from the
wheel well.

Remove the guard cover and the
bolts securing the fender to the
chassis.

Once all the bolts have been
removed from the wheel well, pull
back on it and remove the bolt
securing the fender to the bumper
and body.