Page 1
®
Master Prep® Advantage
QB800UK Series
OWNER’S GUIDE
Page 2
IMPORTANT SAFETY INSTRUCTIONS
For Household Use Only
WHEN USING ELECTRICAL APPLIANCES, BASIC
SAFETY PRECAUTIONS SHOULD ALWAYS BE
FOLLOWED, INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS BEFORE USING YOUR
NINJA® MASTER PREP® ADVANTAGE.
IMPORTANT:
This appliance is not intended for use by persons with
reduced physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they have been
given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
Children shall not use or play with this appliance. Close
supervision is necessary to keep appliance and cord out
of reach of children during use.
WARNING:
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK OR INJURY:
1 To protect against electric shock, DO NOT
immerse cord, plug or any part of the main unit in
water or any other liquids.
2 DO NOT let cord hang over edge of table or
counter, or touch hot surfaces.
3 DO NOT allow children to operate the appliance or
use as a toy. Close supervision is necessary when
any appliance is used near children.
4 DO NOT use with damaged cord or plug.
5 DO NOT USE if the appliance is not working, has
been dropped, dropped into water, damaged or
left outdoors.
6 NO SERVICEABLE PARTS. Incorrect re-assembly
or repair can cause a risk of electrical shock or
injury to persons when the appliance is used.
Contact Customer Service.
7 Unplug appliance from outlet when not in use and
before cleaning.
8 Turn the appliance off and remove the power cord
from the electrical outlet when not in use, before
assembling or disassembling parts, accessing
parts that move while in use and before cleaning.
To unplug, grasp the plug and pull from the
electrical outlet. Never pull from the power cord.
9 DO NOT place on or near a hot gas or electric
burner.
10 DO NOT operate the appliance for more than
15seconds.
11 DO NOT operate the appliance empty.
12 Extreme caution must be used when moving
an appliance containing hot food, water or
otherliquids.
13 Use this appliance on a stable work surface away
from water.
14 DO NOT remove the motor head before the
chopping blades have stopped turning.
15 CAUTION! Chopping blades are sharp, handle
with care. When handling the chopping blades,
always hold by the plastic shaft.
16 DO NOT attempt to sharpen blades.
17 DO NOT expose pitcher to extreme
temperaturechanges.
18 DO NOT use pitcher if it is cracked or chipped.
19 DO NOT use the appliance if chopping blades are
bent or damaged.
20 Avoid contact with moving parts at all times. Keep
hands, hair, clothing as well as spatulas and other
utensils away from pitcher during operation to
prevent risk of personal injury and /or damage to
the appliance.
21 CAUTION: DO NOT PROCESS HOT FOODS
OR HOT LIQUIDS. Allow hot ingredients to cool
before processing.
22 Immediately release the On/Off pulse button on
the motor head in the event that the appliance
malfunctions during use.
23 To reduce the risk of injury, NEVER operate the
appliance without the splash guard in place;
DO NOT try to defeat the interlock mechanism;
make sure that the cutting blades are properly
assembled before operating the appliance.
24 DO NOT use outdoors.
25 DO NOT use appliance for other than
intendeduse.
26 If the appliance overheats, a thermal switch will
become activated and shut off the motor. To
reset, unplug the appliance and let it cool down
for approximately 10 minutes before using again.
27 The use of accessory attachments, including
canning jars not recommended by EURO-PRO
Operating LLC may cause fire, electrical shock or
risk of personal injury.
NOTE: This unit has a short power supply cord to reduce
the risk resulting from becoming entangled in or
tripping over a long cord. An extension cord may be
used if you are careful in its use.
1 If using an extension cord, the electrical rating
of the extension cord should be rated at least
15 amperes. Extension cords rated for less
amperage may overheat.
2 An extension cord must be arranged so that it will
not drape over the countertop or tabletop where
it can be pulled on by children or tripped over
accidentally.
SAVE THESE
INSTRUCTIONS
1 2
Freep hone 0 800 8 62 04 53 www.ninjakitchen.eu
Page 3
This appliance complies with the WEEE-Directive 2012/19/EU on the disposal of electrical and electronic equipment (WEEE ).
Contents
This marking indicates that this product should not be disposed with other household wastes throughout the
EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material sources. To return your used device, please use the
return and collection systems or contact the retailer where this product was purchased. They can take this
product for environmental safe recycling.
This appliance complies with the European directives for electromagnetic compatibility (EMC) 2004/108/EC and its revisions,
as well as Low Voltage Directive ( LVD) 2006/95/EC and its revisions.
Guarantee: This product is unconditionally guaranteed for one year against all defects of workmanship and materials. This
guarantee does not affect your statutory rights. If this product proves unsatisfactory please contact our customer service
department on freephone 0800 862 0453 or by e-mail ukser vice@euro-pro.com.
Thank you for
purchasing
the Ninja
Master Prep
®
®
Advantage.
Getting Started .......................................................................................................................... 5
Using the Master Prep® Advantage Pitcher .................................................................................. 6
Cleaning and Maintenance ......................................................................................................... 8
Troubleshooting Guide ................................................................................................................ 8
THIS MANUAL COVERS MODEL:
QB800UKCR 30
QB800UKRD 30
QB800UKBK 30
TECHNICAL SPECIFICATIONS
Voltage: 220-240V~, 50/60Hz
Power: 500 Watts
Pitcher Capacity: 1.25 L
Euro-Pro, Master Prep and Ninja are
trademarks of Euro-Pro Operating LLC.
3 4
Freep hone 0 800 8 62 04 53 www.ninjakitchen.eu
500 Watt Power Head
NEVER allow the power head to become wet when plugged into an electrical outlet.
WARNING: The power head should never be immersed in water or any other liquid.
CAUTION: Make sure that the power head is unplugged from the electrical outlet and that the blades have stopped turning
before attaching or removing any accessory.
CAUTION: Blades are sharp! Use extreme caution when handling the blades. Always hold them by the shaf t.
Do not attempt to sharpen blades.
IMPORTANT: Never run the appliance empty.
Page 4
Getting Started
Using the Master Prep® Advantage Pitcher
a
b
c
d
®
The Ninja
Master Prep® Advantage is an indispensable kitchen tool that is perfect for blending, whipping, ice crushing
and food processing - all in the conveniently sized ‘Advantage’ pitcher! For best results, be sure to carefully read all the
instructions contained in the manual before using this appliance.
c
Shaft
e
a
f
b
Fig. 2
Fig. 1
g
CAUTION: Blades are sharp! Use extreme caution when
handling the blades. Always hold them by the shaft.
IM PO RTANT: Never run the appliance empty.
h
1 Place the Master Prep
®
Advantage Pitcher on a clean, dr y,
level surface.
2 Holding the blade by the shaft, place it onto the spindle pin
inside the pitcher. (Fig. 1, a)
IM PO RTANT: Place blade inside the container carefully as
a On/Off Pulse Button
b Power Head
c Pouring Spout
d Splash Guard
®
e Ninja
4-Blade
5 6
Freep hone 0 800 8 62 04 53 www.ninjakitchen.eu
f Master Prep™ Advantage 1.25 L Pitcher with Non-Slip Base
g Spindle Pin
h Pitcher Storage Lid
i Power Cord (not shown)
blades are sharp.
WARNING: DO NOT try to place the blade onto the power
head and then into the pitcher. (Fig. 1, b)
3 Add the ingredients to be processed into the pitcher.
IM PO RTANT: Never add ingredients into the pitcher before
placing the blades in first.
4 Place the pitcher splash guard onto the top of the pitcher.
(Fig. 1, c)
5 Place the power head on top of the pitcher splash guard
making sure that it is securely in place. (Fig. 2)
WARNING: DO NOT attempt to operate the appliance
without the safety splash guard in place.
NOTE: DO NOT add more than 1.25 L dry or 1.25 L liquid
ingredients as this will strain the motor and may cause overflow.
Page 5
Using the Master Prep® Advantage Pitcher - cont’d Cleaning and Maintenance
CAUTION: Make sure that the power head is unplugged from power source before inser ting or removing any attachment and
before cleaning.
DO NOT immerse the power head into water or any other liquid. Clean with a damp sponge or cloth and wipe dry.
The Master Prep
place the storage lid and the blades on the top rack. Use extreme caution when handling the blades as they are very sharp.
Clean the Ninja
®
Advantage pitcher, storage lid, splash guard and blades are all dishwasher safe. It is recommended to
®
Master Prep® Advantage and all parts before first use and immediately after each use.
Troubleshooting Guide
PROBLEMS POSSIBLE REASONS & SOLUTIONS
6 To start the appliance, plug the power cord into the
electrical outlet, securely hold power head while operating
and press on the On/Off pulse button located on the top of
the power head. (Fig. 3)
7 Hold the pitcher firmly while depressing the On/Off pulse
button to ensure the unit stays in place.
NOTE: DO NOT operate the appliance continuously for more
than 15 seconds at a time.
8 To stop the appliance, remove your fingers from the On/Off
pulse button.
9 In order to obtain a better quality of chopping, operate the
appliance by using the “pulse” method.
10 Make sure that the blades have stopped completely before
removing the power head.
11 If the ingredients stick to the side of the pitcher, stop the
appliance, remove the power head and the splash guard.
Use a spatula to dislodge the pieces and then replace the
splash guard and the power head. Continue processing.
12 Depending on the consistency of the contents, use the
pouring spout to empty liquid contents.
13 For thicker consistencies, first remove splash guard and
blade (by its shaft), then empty contents of the pitcher.
Fig. 3
HINTS & TIPS FOR USING YOUR NINJA®
MASTER PREP® ADVANTAGE
• The chopping blades can be used for chopping meat, fish,
vegetables, cheese etc.
• For mincing, chopping and pureeing, increase the length of
pulses.
• For coarse chopping, use short, quick pulses and monitor
food texture.
• Pre-cut larger pieces to make them fit into the Master
®
Prep
Advantage. When chopping hard foods (e.g. meat,
cheese) cut into 1-inch cubes.
• To crush ice into snow, start by using short pulses to break
up large chunks. Continue until snow is achieved.
Motor Doesn’t Start or Blades
Don’t Rotate.
Food is Unevenly Chopped.
Food is Chopped Too Fine or is
Too Watery.
Food Collects On Splash
Guard/Safety Cover or On the
Sides of the pitcher.
You Cannot Achieve Snow
From Solid Ice.
To purchase replacement parts, please visit our website: www.ninjakitchen.eu
Check that the bottom of motor head is clean and there is no food blocking
connection when placing on containers.
There is too much food in the pitcher.
The unit has overheated. Unplug and wait approximately 10 minutes before using again.
Make sure the splash guard is securely on pitcher.
Make sure the power head is securely placed on splash guard.
Check that the plug is securely inserted into the electrical outlet.
Check fuse or breaker. Replace fuse/reset breaker.
Either you are chopping too much food at one time, or the pieces are not small
enough. Try cutting the food into smaller pieces of even size and processing smaller
amounts per batch.
The food has been over processed. Use brief pulses or process for shorter time. Let
blades stop completely between pulses.
You may be processing too much food. Turn the machine Off. When the blades stop
rotating, remove the power head and the splash guard. Remove some of the food
being processed.
Do not use ice that has been sitting out or has started to melt. Be sure to use short
pulses in the beginning to break up large pieces.
or contact customer service:
0800 862 0453
7 8
Freep hone 0 800 8 62 04 53 www.ninjakitchen.eu
Page 6
Notes Notes
9 10
Freep hone 0 800 8 62 04 53 www.ninjakitchen.eu
Page 7
Euro-Pro Europe Limited
15 Mariner Court
Calder Park
Wakefield
WF4 3FL
Freephone 0800 862 0453
www.ninjakitchen.eu
Copyright © 2014 Euro-Pro Operating LLC
Euro-Pro, Master Prep and Ninja are trademarks of
Euro-Pro Operating LLC.
Technical Details
Model number: QB800UK Series 30
Voltage: 220-240V~, 50/60Hz
Power: 500 Watts
Printed in China
Illustrations may differ from actual product.
QB800UKseries_30_IB_ENG_150611_2
Loading...