Ningbo WinHi Electronics and Technology EYE BT 00001 User Manual

Stereo Bluetooth Transmitter
User Manual

1. Picture:

2. Specification
Chip: CSR BC57E687C
Version: V3.0
Protocols: A2DP 2.0
Instruction light: red light, bule light
Input Voltage: 5V
Supply Current: 30-50mA

3. Working Mode
After power on, the BT transmitter will turned on automatically, and pairing the last bluetooth
receiver(the blue light will be flashing). If the pairing is not connected within 10 seconds, it will
automatically enter pairing state (red and blue lights will be flashing cross).
If the BT transmitter is successfully connected with bluetooth receiver , blue light will be on.
If the BT transmitter connected with a not matchable device, it will automatically disconnect and
enter pairing status. If there is no connection within five minutes, the transmitter will enter
standby mode, and blue light flashes slowly.

4. Name of device
This model of bluetooth transmitter can only connected with device which is named “Music Flow
H3”. If the former 13 characters of the bluetooth receiver name is same as “Music Flow H3”, the
2 device can connect successfully.If any of the first 13 characters is not the same, t he connection
will be failed.
If you need to connect with other names of devices, you have to modify the name of bluetooth
transmitter, which shoud be same as receiver device. If the receiver name is more than 13
characters, letters after 13 characters will be negligible.

FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and,
if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:

‐‐ Reorient or relocate the receiving antenna.
‐‐ Increase the separation between the equipment and receiver.

‐‐ Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.
‐‐ Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation