Ningbo Polinata Electronics M 2500 User Manual

INSTRUCTION MANUAL
M-2500
15
15
1 2500 W 8
POWER
3
4
10
5
17
6
CLIP
18
7
1
2
9
8
11
12
SCAN
LEVEL
LEVEL
MAX
MIN
MIC1 MIC2
CH1 CH2 CH3
15
14
LEVEL
LINE INP UT
R L
16
MP3 LEVE L
MAXMIN
MAXMIN
TREBLE
-12dB +12dB BASS
-12dB +12dB
13
19
LINE OUT PUT
115V 230 V
22
20 21
SPEAKE R OUT
8Ω
ON
23
OFF
POWER
OFF ON
AC 115/23 0V 60/5 0Hz
1.LCD scree n
MODE:USB/SD /B T/FM conver to r
2.
:Play / Pause SCAN:Long p re ss to auto search u nd er FM radio :Repeat one / R ep eat all / Random :PRE/NEXT und er FM mode Long hold to se ar ch lower/ higher stat io n manually :Short pres s to t une to saved stat io n :Previous S on g Long press fo r fa st rewind :Next Song Long press fo r fa st forward
3.
SD card input
4.USB input
5.MP3 level c ontrol
6.Treble con trol for high f re quencie s
7.Bass cont ro l for low fre qu encies
LED
24
8.MIC1 inpu t level contr ol
9.MIC2 inpu t level contr ol
10.Line inp ut level cont ro l
11.XLR micro phone1 inpu t
12.XLR micr ophone2 inp ut
13.XLR line i nput
14.6.35 mic ro phone1 ch an nel line inpu t
15.6.35 mic ro phone2 ch an nel line inpu t
16.RCA phone(R +L ) line input
17.Power LE D indicator
18.Clip LED i ndicator
19.XLR line o utput
20.Speake r ou t 8 Ohm
21.
LED Light Switc h( ON /OFF)
22.115/230V Swit ch
23.
Main power sw itch
24.Fused IE C ma ins inlet
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:(1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Loading...