NINGBO JINGHUI OPTO ELECTRONIC KF01 02 User Manual

Keyfinder receiver

Each requires one CR2032 button cell battery (included).

NOTE: There are four CR2032 button cell batteries included. Two must

be installed prior to your first use and the other two are replacements.

Follow these steps for first time installation or if the batteries need to be

replaced.

1. Grasp the back cover and screw off counterclockwise.

2. Insert a new battery into the metal slot, ensuring the “+” side

of the battery is facing up. The fob will make its characteristic

beeping sound as it is inserted into the slot.

3. Replace the back cover by screwing it clockwise back onto the fob.

NOTE: Be sure that the "OPEN" markings are facing the bottom as you

screw on the cover. This will ensure that the pieces are properly

aligned.

FCC STATEMENT

1. This device complies with Part 15 of the FCC Rules. Operation is

subject to the following two conditions:

(1) This device may not cause harmful interference.

(2) This device must accept any interference received, including

interference that may cause undesired operation.

2. Changes or modifications not expressly approved by the party

responsible for compliance could void the user's authority to operate the

equipment.

NOTE: This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is

no guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on,

the user is encouraged to try to correct the interference by one or more of

the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.