NINGBO CSTAR IMP and EXP 0064 User Manual

100mm

Bluetooth Speaker Bottle

Instructions

Product Specifications
Model : SL293
Item No.: KB-41
Output Power : 3W X 1
Frequency response : 20HZ-20KHz
Input : DC5V/300mA
Transmission range: 10m
Battery: 300 mAh

146mm

1

Turn on
Long press the button

3

Play music

KB-41

2

Open the Bluetooth in your
phone, select “KB-41”.

4

Turn off
Long press the button

5

7

Charging

6

Cup and lid can be separated
or put together

WARNING

1. Do not place speaker portion in water. Always remove

bottle portion for cleaning.

2. Do not expose to exterior moisture or rain.

3. Always recharge speaker in a well ventilated area. Do

not expose to extreme temperatures for extended
periods of time.

4. Keep away from flame and other sources of ignition.

FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received,
including interference that may cause undesired operation.

Warning:
Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.

Note:This equipment has been tested and found to comply with the limits
for a class B digital device,pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation.
This equipment generates uses and can radiate radio frequence energy and,
if not installed and used in accordance with the instructions,may cause
harmful interference to radio communications.However,there is no
guarantee that interference will not accor in a particular installation.if this
equipmemt does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on,the user is
encouraged to try to correct the interference by one or more of the
following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an autlet on a circuit different from that to

which the receiver is connectec.

• Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement.
The devicecan be used in portable exposure condition without restriction.

The Bluetooth® word mark and logos are registered trademarks owned

by Bluetooth SIG, Inc. and any use of such marks by (ShenZhen C-Star

Electronic Tech. Co., Ltd.) is under license. Other trademarks and trade
names are those of their respective owners.

FCC ID : 2ABHA0064
Bluetooth Listing Declaration ID: D026369 Made in China

Front Back