NINGBO CSTAR IMP and EXP 0049 User Manual

Congratulations on your BT Home speaker with wireless charger!
This BT speaker allows you to enjoy your music without wires and charge your
phone at the same time.
Please read this manual before use.

NOTE: Wireless charging option is only possible if the micro USB cable is
connected.

DEVICE LAYOUT:

1. Wireless charger transmitter

2. Pause/Play button (short press)

3. Previous track

4. Volume -

5. Micro USB

CHARGING THE SPEAKER:

A full charge is approximately 3 hours and plays continuously 6-7 hours.
Connect the speaker to the USB charging cable to charge.
When the LED indicator is RED, the speaker is charging.

6. Next track

7. Volume +

8. Speaker

9. Microphone

10. LED indicator for speaker

HOW TO USE: FCC Statement:

If you want to pair your mobile device with the speaker, please make sure the

to pair the device. After doing so the speaker will be visible in the BT devices
overview of your device. Please select “Home wireless speaker’’ to pair your
mobile device with the speaker.

USING THE WIRELESS CHARGER:

• Make sure your phone is compatible for wireless charging.

• First plug the wireless charger using the included micro USB cable into the

USB port of your wall adapter. Please note charging speeds depends on the
input power into the wireless charger.

• Place your mobile phone on the charging pad. You can check the charging
status on the screen of your phone.

FUNCTIONS:

Accept call – Press pause/play button.
Ending call – Press pause/play button.
Changing Volume: Press the + or – button shortly.
Changing track: Press |>> or |<< button shortly.

SPECIFICATIONS:

Model: SL218
Item No.: 32269
Input: 5V/2A
Battery capacity: 2000 mAh
Output: 5W
Wireless charger output: 5V/0.8A
Frequency response : 90Hz-20KHz
S/N Ratio: ≥85db

•

This device complies with Part 18 of the FCC Rules
The interference potential of the device or system.

•

Maintenance of the system.

•

•

Simple measures that can be taken by the user to correct interference.

MADE IN CHINA

FCC ID : 2ABHA0049

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions:
(1)This device may not cause harmful interference.
(2)This device must accept any interference received, including interference that may
cause undesired operation.

2. Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Note:This equipment has been tested and found to comply with the limits for a class B
digital device,pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequence energy and,if not
installed and used in accordance with the instructions,may cause harmful interference to
radio communications.However,there is no guarantee that interference will not accor in a
particular installation.if this equipmemt does cause harmful interference to radio or
television reception,which can be determined by turning the equipment off and on,the user
is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an autlet on a circuit different from that to which the

receiver is connectec.

• Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The devicecan
be used in portable exposure condition without restriction.