Bluetooth Cube Speaker with Rubber Band
Product Specifications
Model：
SL038
Power Output：3W X 1
SNR: ≥70dB
Frequency：20HZ-20KHz
Input：DC5V/300mA
Impedance：4Ω
Battery : 300mAh
Using Bluetooth with the SL038
1
3
OFF ON
5
Once paired, You can then stream audio to the speaker.
2
Slide the ON/OFF switch on the speaker to the ON position.
Open your divce bluetooth mode
4
“BT SPEAKER” should appear on your device.
If “Not Connected” or similar message appears,
select “BT SPEAKER”” to connect.
7
To charge the battery connect the larger plug of the
included USB charging cable to the powered USB port
of USB/AC adapter.
ON OFF
LED
BT SPEAKER
6
CHARGE UNIT BEFORE USE
ON OFF
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference.
(2)This device must accept any interference received, including interference that ma y cause undesired
operation.
2. Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
Note:This equipment has been tested and found to comply with the limits for a class B digital
device,pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequence energy and,if not installed and
used in accordance with the instructions,may cause harmful interference to radio
communications.However,there is no guarantee that interference will not accor in a particular
installation.if this equipmemt does cause harmful interference to ra dio or television reception, which can
be determined by turning the equipment off and on,the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment a nd receiver.
• Connect the equipment into an autlet on a circuit different from that to which the receiver is
connectec.
• Consult the dealer or an experienced radio/TV technician for help.
This equipment should be installed and operated with a minumum distance of 20 cm between the
radiator and your body.
This device has been evaluated to meet general RF exposure requirement .The
portable exposure condition without restriction.
device can be used in
Loading...