NINGBO CSTAR IMP and EXP 0013 User Manual

PL-1352 Lynx Power Bank

A.V : Accessories Lithium ion battery

Model: SL019
Item No.: PL-1352
Input: DC 5V/550mA
Maximum input: DC 5.3V/600mA
Output: DC 5V/1000mA
Battery/Cell capacity: 3.6V / 2200mAh, 7.92Wh
Product capacity: 5V / 1460mAh, 7.3Wh
Operating temperature: 0~45°C for Charging

Product Name: Bluetooth SpeaKer Power Bank

EN

CAUTION: Risk of Fire and Burns, don’t open, crush,

disassemble and dispose of in fire. Accessible surfaces
held or touched for short periods only. Don’t heat above
50 °C or Incinerate. Follow Manufacturer’s Instructions.

FR

DANGER: risque d’incendie et de brûlures, ne pas ouvrir,

démonter, écraser ni jeter au feu. Ne pas toucher ou tenir
les surfaces accessibles sur une longue durée. Ne pas
chauffer au-dessus de 50 ° C. Instructions de fabricant Suivre.

MADE IN CHINA

FCC ID:2ABHA0013

UL 2056 certified

0~50°C for Discharging

3

4

1. 5V Input Port (Micro USB)

2. 5V Output Port (USB A-type)

3. Bluetooth Button

4. LED indicator

5. 3.5mm AUX Line-in Port

5
1
2

How to use

1. Pairing adevice in bluetooth mode:

BT SPEAKER

2. Charging the portable Power bank

a. Using your mobile phone’s USB adapter. Connect a USB
cable to your phone’s USB adapter. Using the micro USB
connector, connect the other end of the USB cable to the IN
port on the portable Power bank. Plug the USB adapter into
the outlet to begin charging.
b. Using your computer. Connect a USB cable to a USB
outlet on your computer. Using the micro USB connector,

FRONT

connect the other end of the USB cable to an IN port on the
portable Power bank. Make sure the computer is on to begin
charging the portable Power bank.

3. Charging mobile phones and other electronic devices.

a. The portable power device has a USB output port which
has the maximum output current of 1000 mA.
b. Connect to USB cable to your mobile phone/device using
the appropriate connector. Connect the other end of the USB
cable to the OUT port of the portable Power bank. Your
mobile phone/device should display the status of charging.
c. Remove the USB cable from your mobile device when it is
fully charged.
Note: In order to charge device use only accessory cable
(provided with power bank) or the cable included with your
own device by the manufacturer.

WARNING – When using this product, basic precautions
should always be followed, including the following:

1. Read all the instructions before using the product.

2. Power bank main unit contains an internal lithium ion
battery. Upon initial use or after a prolonged storage period,
fully charge it once. The unit’s full performance is achieved
only after 2 or 3 completed charge and discharge cycles.

3. Power banks are not allowed in checked luggage on
commercial airline flights. Handle with care and dispose of in
accordance to local regulations. Carry-on only.

4.To reduce the risk of injury, close supervision is necessary
when the product is used near children.

5. Do not put fingers or hands into the product.

6. Do not expose power bank to rain or snow.

7.Use of a power supply or charger not recommended or sold
by power pack manufacturer may result inarisk of fire or

injury to persons.

8. Do not use the power bank in excess of its output rating.
Overload outputs above rating may result inarisk of fire or
injury to persons.

9. Do not use the power bank that is damaged or modified.
Damaged or modified batteries may exhibit unpredictable
behavior resulting in fire, explosion or risk of injury.

10.Do not disassemble the power bank. Take it toaqualified
service person when service or repair is required. Incorrect
reassembly may result inarisk of fire or injury to persons.

11.Do not exposeapower pack to fire or excessive temperature.
Exposure to fire or temperature above 100°C may cause
explosion. The temperature of 100°C can be replaced by the
temperature of 212°F.

12.Have servicing performed byaqualified repair person using
only identical replacement parts.This will ensure that the
safety of the product is maintained.

13. Do not use the phone or device when charging by the 2 in 1
AC adapter Power bank. Do not charge the power bank for more
than 4-6 hours and do not leave unattended.

14.Disconnect the power bank when not in use.

Warning:
Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.

SAVE THESE INSTRUCTIONS

FCC STATEMENT

This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the
FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for
help.
To assure continued compliance, any changes or
modifications not expressly approved by the party.
Responsible for compliance could void the user’s authority to
operate this equipment. (Example- use only shielded interface
cables when connecting to computer or peripheral devices).
This equipment complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
RF warning statement:
The device has been evaluated to meet general RF exposure
require

BACK