Page 1
1
4
Warrior/34RST with EcoFlex How To
This is how the
machine should look
when you enter the
room.
Fill solution tank with
water (do not exceed
130°F). Add appropriate
cleaning chemical.
Prepare for use
2
Unplug battery charger.
Wrap cord accordingly.
5
Do not mix detergent in
the tank for EcoFlex
models.
3
Inspect recovery tank
then lower the lid.
6
Inspect squeegee
blade, install squeegee
on machine and attach
recovery hose to the
squeegee inlet.
7
Inspect brush or pad.
10
Turn on machine. Verify
there is enough battery
life to complete job.
8
11
Install brush or padholder under the deck.
Use paddle to move
forward or reverse.
Adjust speed of
machine as needed.
9
Install brush for
Cylindrical models
12
Turn on scrub switch,
lower squeegee lever
and begin scrubbing.
Page 2
1
Empty recovery tank
and solution tank.
Empty water in suitable
drain or bucket.
Warrior/34RST How To
Store the Machine
2
Wash recovery tank
and vacuum grid inlet
filter with clean water.
3
Remove vacuum motor
inlet screen. Do not
allow water to enter the
Vacuum motor inlet
screen while cleaning.
4
Inspect hoses; replace
if kinked or damaged.
7
Lift recovery tank lid.
5
Remove, rinse and
inspect squeegee.
Replace if needed.
8
Charge batteries.
6
Remove, clean and
inspect brush or pad.
Rinse with warm water.
Hang to dry. Replace if
needed.
9
Wipe down exterior of
the machine.
Page 3
Maintenance
1
4
Charge Batteries
Check, clean and rotate
the brushes/pads.
Warrior/34RST How To
Daily Maintenance
2
Check and clean
recovery and solution
tank and hoses.
5
Clean and check the
squeegee.
3
Clean recovery tank
switches and vacuum
inlet screen.
6
Clean Hopper on
Cylindrical models.
Weekly Maintenance
1
Inspect scrub housing
skirts
4
Clean solution
manifolds on Cylindrical
models.
(34 RST models)
2
5
Inspect and clean
solution filter.
Disconnect and remove
cartridge, turn machine
ON. Press and hold the
solution switch for 2
seconds.
3
Check each battery cell
6
water level
apply to gel batteries)
Occasional
Monthly: Apply light oil
to lubricate machine
(see manual for details)
Yearly:
Check carbon brushes
(does not
Loading...