56104403 ONBOARD CHARGER KIT-EU
SC1500 Model: 56104002
CONTENTS OF KIT
ITEM PART NO. QTY DESCRIPTION
[ ] 56090145 1 Instruction Sheet
1 L08603744 2 Screw Pan Hd M5 X 16 SS
2# 1458280000 2 Washer Plain M5X15 SS ISO7093
3 9095149000 1 Cable Support
4 56114378 1 Battery Charger 24V 25A
5 56477613 6 Tie, Cable
6# 56383388 1 Cord-Charger Europe
7# 56383389 1 Cord-Charger UK
8 L08603689 4 Flat Washer M6 X 18 SS
9 33005604 4 Nut Hex Nyl Loc Thin M6
10 33005603 2 Self-Locking Nut M5
[ ] = Not Shown
# = Revised or new since last update
10
1
3
2
4
5
6
8
© 2018 Nilfi sk, Inc.
9
7
8/2012 revised 8/2018 Form No. 56090145 REV H(page 1 of 7)
INSTALLATION INSTRUCTIONS
WARNING!
DISCONNECT BATTERIES BEFORE SERVICING.
MOUNT BATTERY CHARGER TO MACHINE AND CONNECT TO HARNESS
1 See Figure 1. Remove P-Clamp (P) from the machine and save. This P-Clamp is currently holding the wiring harness out of the way and will be re-used.
2 Mount the Battery Charger (4) to the underside of the chassis as shown using Hardware Items (8 & 9), also re-using P-Clamp (P) at this time to secure the wiring
harness up and out of the way as shown in Figure 2.
3 Connect the large connector (A) with the BLK and RED wires from the Charger to the large connector (B) with the BLK and RED wires from the machine harness.
4 Connect the connector (C) with three wires from the Charger to connector (D) also with three wires (BRN, RED/VIO & YEL/ORN) from the machine harness.
NOTE: Connector (D) has a protective plug that must be removed fi rst. Steps continued on Page 3.
FIGURE 1
IT IS NOT NECESSARY TO REMOVE THE DECK.
SHOWN WITH DECK REMOVED FOR CLARITY.
C
B
A
4
P
D
FIGURE 2
Machine Harness
P
© 2018 Nilfi sk, Inc.
8
9
8/2012 revised 8/2018 Form No. 56090145 REV H(page 2 of 7)
MOUNT BATTERY CHARGER TO MACHINE AND CONNECT TO HARNESS continued
5 See Figure 3. Bundle the charger wires and secure them close to the charger using Cable Ties (5) as needed. NOTE: Secure the charger wiring close to the
charger and away from the Solution Drain Valve (E). The solution drain hose needs to be able to rotate down and the drain valve turned ON & OFF without any
interference from the charger wiring. The squeegee must be able to rotate without the squeegee or squeegee hose coming into contact with any of the charger
wiring or the plug to the platform during operation.
FIGURE 3
E
5
© 2018 Nilfi sk, Inc.
8/2012 revised 8/2018 Form No. 56090145 REV H(page 3 of 7)
Loading...