1
4
Focus II Mid-Size How To
This is how the
machine should look
when you enter the
room.
Fill solution tank with
water (do not exceed
130°F). Add appropriate
cleaning chemical.
Prepare for use
2
Unplug battery charger.
Wrap cord accordingly.
5
Add clean water to
tank. Lift lid and add
detergent cartridge. Do
not mix detergent in the
tank (machines with chemical
mixing system only).
3
6
Inspect recovery tank,
empty debris catch
cage then lower the lid.
Inspect squeegee
blade, install squeegee
on machine and attach
recovery hose to the
squeegee inlet.
7
10
Inspect brush or pad.
Turn on machine. Verify
there is enough battery
power to complete job.
8
Install brush or padholder under the deck.
Use yellow palm
11
switches to move
forward and white
button for reverse.
Adjust speed of
machine as needed.
9
12
Install brush for
Cylindrical models.
Review operator
controls. Prepare
use.
for
1
Adjust speed if needed.
Lower squeegee.
Focus II Mid-Size How To
2
Scrubbing
While in motion, press
the one touch scrub
button then adjust the
solution flow rate.
3
Release palm switches
to pause. Press reverse
button for backward
motion. Press one
scrub button to stop
scrubbing.
4
Use the extra pressure
button for heavy soiled
areas (disc and Boost
machines only).
7
Pre-wet stripping pad.
Adjust to slow speed
5
Vacuum on/off. Vacuum
only to pick up water.
Turn vacuum off for
double scrubbing.
8
Lower squeegee and
engage extra pressure
to begin scrubbing
6
Install red pad and
maroon pad for
chemical free stripping.
Add plain water to the
solution tank.
9
Flip pad when it
becomes worn. Scrub
floor before laying down
new finish.
1
Empty recovery tank
and solution tank.
Empty water in suitable
drain or bucket. Rinse
recovery tank. Empty
and rinse debris catch
cage. Check gasket
cover.
Focus II Mid-Size How To
Storing the Machine & Daily Maintenance
2
Remove, inspect and
rinse squeegee blades.
Remove, inspect and
rinse pads. Hang to dry.
Weekly Maintenance
3
Remove, inspect and
rinse cylindrical brush.
Empty debris hopper.
Charge batteries and
wipe down exterior.
1
Inspect water level in
batteries
water if needed – do not
overfill)
1
Lubricate machine;
equalize batteries –
charge fully then
recharge two or more
times.
(add distilled
.
2
Remove and rinse
solution filter.
Occasional Maintenance
2
Annually or after 300
hours inspect carbon
brushes on the vacuum
motor
Authorized Clarke
Service Center)
(performed by
3
Purge the chemical
mixing system
equipped)
.
(if
3
Annually or after 500
hours inspect carbon
brushes on the drive
and brush motors
.
(performed by
Authorized Clarke
Service Center)
.
Loading...