Page 1
1
Familiarize yourself
with the control panel
and how each item
functions before
operating this machine.
ES4000 How To
Prepare for use
2
Turn on the key switch
and check the Battery
Indicator and hour
meter.
3
Fill the solution tank 1/3
with water then add
appropriate chemical.
(Temperature should not
exceed 130°F).
4
7
When using the
detergent dispensing
system Do not mix
chemicals in the
solution tank
water).
Pre-spray spots and
heavy traffic areas
before extracting.
(use plain
5
Use the Sweep Mode
to clean area prior to
extracting
attach the dry hose when
using sweep mode)
8
Gather accessories
needed)
(You must
.
(if
.
6
9
Clean area using
Sweep Mode to
vacuum debris from the
entire area to be
cleaned.
Drive machine to work
location.
Page 2
1
Review control panel for
cleaning mode options.
ES4000 How To
Extract Mode Machine Operation
2
Clean area using the
Extract Mode: press
Extract On switch
.
beep)
(horn will
3
Switch the recovery
hose to Wet Pick up
connection
4
Press the Extract
On/Off switch to
acknowledge hose
change
7
After cleaning is
complete, drive
machine to designated
waste disposal site to
empty the recovery
tank.
(press again).
5
Drive the machine
forward to begin
extraction mode
cleaning.
8
Wipe the exterior of the
machine with a damp
cloth. Leave the lid
open for ventilation.
6
9
Review maintenance
table. Perform any
required maintenance
before storing the
machine.
Page 3
1
Charge batteries and
inspect and clean the
solution and recovery
tanks.
ES4000 How To
Prepare for Storage & Maintenance
2
Remove brushes. Inspect
and clean hoses and
brushes
Weekly Maintenance
(replace if needed)
.
3
Remove and clean
vacuum shoes, debris
hopper, vacuum motor
filter, strainer basket and
vacuum shut-off float.
1
Check each battery cell(s)
water level. Remove the
spray nozzle once a
week.
vinegar to remove chemical
deposits)
Grease fittings:
Steering wheel shaft,
Steering chain, General
MonthlyMaintenance
pivot points, Clean deck
adjustments knobs
(Soak nozzle overnight in
2
Inspect brush scrub deck.
Inspect and clean the
solution filter.
*Authorized Svc. Ctr.
*Check the vacuum
motor carbon brushes
once a year or after
300 operating hours.
YearlyMaintenance
*Check the brush and
drive motor carbon
brushes once a year or
after 350 operating
hours.
3
Purge detergent injection
system. Check
foot/parking brake for
wear & adjustment.
IMPORTANT!
Motor damage due to
failure to service the
carbon brushes is not
covered under
warranty.
Loading...