Nil sk C 100.5
Nil sk C 110.3, C 110.3 X-TRA
User Manual
3
Index
1 Safety precautions and warnings .............................................3
2 Description ...............................................................................5
3 Before you start using your pressure washer ...........................6
4 Operating your pressure washer ..............................................7
5 After using your pressure washer .............................................9
6 Maintenance ...........................................................................10
7 Trouble shooting .....................................................................12
8 Further information .................................................................13
9 Technical data ........................................................................14
10 Declaration .............................................................................14
1 Safety Precautions and Warnings
Before starting
up your highpressure washer
for the fi rst time,
this instruction
manual must be
read through carefully. Save the
instructions for later use.
Safety instructions
marked with this
symbol must be
observed to pre-
vent danger to persons.
This symbol is
used to mark safety
instructions that
must be ob-
served to prevent
damage to the ma-
chine and its performance.
This symbol indicates tips and
instructions to
simplify work and to ensure a
safe operation.
Do not let people who have not
been trained in the use of a
high pressure washer nor read
the instruction manual ope rate
the machine.
This appliance is not intended
for use by children or other
persons without assistance or
supervision if their physical,
sensory or mental capabilities prevent them from using it
safely. Children should be supervised to ensure that they do
not play with the appliance.
Before starting up your machine
please check it carefully for any
defects. If you fi nd any, do not
start up your machine and contact your Nilfi sk distributor.
Especially check:
The insulation of the electric
cable should be faultless
and without any cracks. If the
electric cable is damaged, an
authorized Nilfi sk di stributor
should replace it.
WARNING!
High pressure jets can be
dangerous. Never direct the
water jet at persons, pets,
live electrical equipment or
the machine itself.
Never try to clean clothes or
footwear on yourself or other
persons.
Hold the spray lance fi rmly
with both hands. The spray
lance is affected by a thrust
of up to 16.4 N during ope–
ration.
The operator and anyone in
the immediate vicinity of the
site of cleaning should take
action to protect themselves
from being struck by debris
dislodged during operation.
Wear goggles and protection
clothes during operation.
This appliance has been de-
signed for use with cleaning
agents supplied or recommended by the manufacturer.
The use of other cleaning
agents or chemicals may
adversely affect the safety of
the appliance.
Disconnect from electrical
power supply before carrying
out user maintenance.
To ensure the appliance
Symbols used to mark instructions
4
safety only use original spare
parts from the manufacturer
or approved by the manufacturer.
High pressure hoses, fi ttings
and couplings are important
for the safety of the appliance. Only use hoses, fi ttings
and couplings recommended
by the manufacturer.
Do not use the appliance
if a supply cord or important parts of appliance are
damaged, e.g. safety device ,
high pressure hose and trigger gun.
The appliance is intended to
clean cars and garden etc..
Appropriate ear protection
has to be used.
Never use the machine in
an environment where there
could be a danger of explosion. If any doubt arises,
please contact the local
authorities.
It is not allowed to clean as-
bestos- containing surfaces
with high pressure.
This high pressure washer
must not be used at temperatures below 0°C.
WARNING!
Inadequate extension cables
can be dangerous. Cables on
drums should always be completely unwinded to prevent the
cable from overheating.
If an extension cable is used,
the plug and the socket must be
waterproof and comply with the
below-mentioned requirements
for length and cable dimensions.
1.0 mm² max. 12.5 m
1.5 mm² max. 20 m
2.5 mm² max. 30 m
If the electric cable is
damaged, it must be replaced by the manufacturer
or his service agent or similarly qualifi ed person in order
to avoid a hazard.
Mains power connection
The following should be observed when connecting the
high pressure washer to the
electric installation:
The electric installation shall
be made by a certifi ed electrician and comply with IEC
364.
It is recommended that the
electric supply to this appliance should include either a
residual current device that
will interrupt the supply if the
leakage current to earth exceeds 30 mA for 30 ms.
Water connection
Connection to the public
mains according to regulations.
Inlet hose can be connected
to the water mains with a
max. inlet pressure of 10
bars.
This high pressure washer is
only allowed to be
connected with
the drinking water
mains, when an appropriate
backfl ow preventer has been
installed, Type BA according
to EN 1717. The backfl ow preventer can be ordered under
number 106411177. The length
of the hose between the backfl ow preventer and the high
pressure washer must be at
least 10 metres to absorb possible pressure peaks (min diameter ½ inch).
Operation by suction (for example from a rainwater vessel)
is carried out without backfl ow
preventer. Recommended suction set: 126411387.
As soon as water has fl own
through the BA valve, this water
is not considered to be drinking
water any more.
IMPORTANT! Only use water without any impurities. If
there is a risk of running sands
in the inlet water (i.e. from your
own well), an additional fi lter
should be mounted.
Safety devices
The unloader valve can re-
duce pressure if it exceeds
pre-set values.
Locking device on spray gun
(7a) (see illustration at the end
of this manual):
The spray gun features a locking device. When the pawl is
activated, the spray gun cannot
be ope rated.
Thermal sensor:
A thermal sensor protects the
motor against overloading. The
machine will restart after a few
minutes when the thermal sensor has cooled.
5
2 Description
This high-pressure washer has
been developed for domestic
use within:
- Car, motorbike, boat, caravan, trailer, patio/drive/fl agstones, woodwork, brickwork,
barbecue, garden furniture,
lawn mower
Only use the high-pressure
washer for purposes described
in this manual.
The safety precautions must be
observed to prevent damage
to the machine, the surface to
be cleaned or severe personal
injuries.
2.2 Operation elements
and model survey
See illustration at the end of
this manual.
1 Start/stop switch
2 Water inlet with fi lter (2a)
3 High pressure connection
4 High pressure hose
5 Electric cable
6 Click & Clean spray lance
7 Spray gun with lock (7a)
8 Click & Clean Tornado
®
nozzle
9 Click & Clean Powerspeed®
nozzle
10 Foam sprayer
11 Nozzle cleaning tool
12 Lance and nozzle holder
13 Model tag
14 Holder for electric cable (not
standard on all models)
15. Hexagon key
Specifi cations: See model tag
(13) of machine.
We reserve the right to alter the
specifi cations.
2.1 Application
6
3 Before you start using your
pressure washer
3.2 Mounting of quick
coupling
1. Screw the quick coupling
tight on to the water inlet (2).
Note: The inlet
fi lter (2a) must al-
ways be fi tted in
the water inlet
pipe to fi lter out
sand, lime stone and
other impurities as these will
damage the pump valves.
Caution: Failure to fi t the fi lter
will invalidate the guarantee.
3.1
Mounting of trolley
handle (models with trolley handle)
3.3 Mounting of high pressure hose on spray gun
1. Attach the high pressure
hose (4) to the spray gun (7).
Detach the high pressure
hose by pressing the pawl
(A).
1. Place the trolley handle on
the machine.
2. Secure the handle by mounting the 2 screws. Use the
enclosed hexagon key.
Loading...