Night Guard Home Surveillance System RSTKE-900 User Manual

THIS PRODUCT IS DESIGNED FOR PROFESSIONAL INSTALLATION ONLY

RSTKE-900

PROFESSIONAL 915 MHz REMOTE CAR

STARTER & 6 CHANNEL KEYLESS ENTRY

SYSTEM

With

Two Way Serial Port Data Link

Optional two Way Up grade Available

Compatible

OPERATION MANUAL

Please register your product at:

www.autopageusa.com

1

Auto Page, Inc. has over 25 years of experience in the vehicle security industry
in the United States and is a wholly owned subsidiary of Iwata Electric Co., of
Tokyo, Japan. Iwata has been an industry leader for over 50 years,
establishing a reputation for ingenuity in its engineering capability and
innovative communication products. Auto Page and Iwata maintain a long
tradition of providing the best value to their customers.

CHANGING THE BATTERY IN YOUR TRANSMITTERS

XT-90S: This transmitter uses one (1) 3-volt lithium ion battery (#CR2032)

that is placed with the (+) side facing upward. To replace the battery, you will
need to use a small flat blade screwdriver and a small Philips screwdriver.
Remove the small Philips head screw. Then locate the small notch on the
lower right side of the transmitter case next to the key ring. Using the flat blade
screwdriver, carefully pry the top case from the bottom case. It should snap
apart after breaking the seal. Before removing the battery note the direction of
the positive (+) terminal. Place the new battery in exactly the same manner,
being careful not to bend or damage the contact terminal. Snap the cases
back together and then test the transmitter to insure it arms and disarms the
alarm. Reinstall the Philips screw to finalize the battery replacement.

XT-90S Extended Range Sliding Cover remote

2

CR2032 3-Volt Battery

Press the

button to stop.

WARNINGS:

As with any product that performs automatic functions, there are certain safety
precautions that you must practice and be aware of.

1. Keep the transmitter out of children’s reach.

2. Do not leave anyone in the vehicle while running on remote control.

3. Alert servicing personnel that the vehicle can be started automatically.

4. Do not start the vehicle by remote while it’s in an enclosed area or garage.

5. Always apply the parking brake and lock the vehicle as you exit the vehicle.

6. The vehicle windows must be rolled up.

7. Should the unit malfunction, disconnect the fuse until the problem is
corrected.

8. The use and operations of this system is the sole responsibility of the
operator.

9. Some areas may have local ordinances that prohibit leaving a vehicle
running on public streets.

10. It is not safe to remote start the vehicle if the vehicle is parked on a steep

incline.

OPERATION:

A. REMOTE TRANSMITTER OPERATION:

Transmitter
Button

-

+

+

+

System Function Remark
Lock Doors
Panic function

Car Locator Under armed mode
Unlock Doors

Two Steps Door Unlock &
Disarm System

Trunk Release (Channel 3) Press and Hold for 2 seconds
Activate or Turn Off The

Remote Start
Channel # 4 Timer Output ( 4)

Channel # 5 Timer Output ( 5)
Channel # 6 Timer Output ( 6)

Press and Hold for 3 seconds.

Press twice within 3 seconds.

Press twice within 3 seconds if programmed
for safety start

ACTIVE LOCK:

3

1. Press button on the transmitter.

2. The horn, if installed will chirp once and parking lights will flash once
indicating that the system is now active. The vehicle doors will lock upon
activating when interfaced with the keyless entry system.

ACTIVE UNLOCK:

1. Press button on the transmitter.

2. The horn will chirp twice and parking light will flash twice to indicating

that the keyless system is now unlocked. The vehicle doors will unlock
and dome lights will turn on for 30 seconds.

PATHWAY ILLUMINATION:

This feature turns the parking light “ON” for 30 seconds upon an unlock
signal and for 10 seconds upon the lock signal. (Programmable)

TWO STEPS DOOR UNLOCK: (programmable) (optional)

T his feature will independently unlock the driver’s door only when
disarming the security system. Pushing the button a second time

within 3 seconds will unlock the other doors.

DEACTIVATING WITHOUT A TRANSMITTER:

The Override function may be used if the remote transmitter is lost or
inoperative.

1. Enter the vehicle and turn the ignition switch to ‘ON’ position.

2. Within 10 seconds push and release the valet switch

VALET MODE:

The valet switch allows you to temporarily bypass all system function,

eliminating the need to hand your transmitter to parking attendants or
garage mechanics. When the system is in valet mode, and remote
start functions are bypassed, Enter Valet Mode:

1.From the Unlock condition, turn the ignition to “ON” position.

2.Push an d hold valet switch for 2 seconds until the LED turns on. The
LED will remain on as long as the system is in ‘valet mode’.

Exit Valet Mode:

1. Return to normal operation, turn ignition ‘on’.

2. Push and hold valet switch for 2 seconds, The LED will turn off

indicating the system has exited the valet mode.

4