Page 1
FCC NOTICE
WARNING : The antenna must be installed i n a manner that ensures a
minimum separation distance of 20 centimeters between the antenna and
human beings.
Page 2
.RF Radiation Exposure
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This equipment must be installed and operated with a minimum distance of 20
centimeters between the radiator and your body.
.Warning ! No user serviceable parts
Alteration or modification to any part of this equipment, without the prior written consent of
the manufacturer,
will invalidate all manufacturer approvals and warranty. No adjustments can be undertaken
except by qualified
and licensed persons as defined by the FCC Rules and Regulations. Operation of altered
equipment can result
in fines, imprisonment, and /or confiscation of such equipment.
Page 3
User Manual
1. Send message - individual
LCD display = Enter Pager no.
Press pager number and press "send"
2. Send message - to all pagers group
LCD display = Enter Pager no.
Press 9111 and press "send"
3. Set time
Press "set up"
LCD display = Set Current Time
Press times and minutes, and press any numeric buttons to choose AM or PM.
If everything is correct, press "select" to set up.
If any mistakes, press "Enter"
You can chage times, minutes and AM or PM.
Once corrected, press "select" to set up.
4. Password
LCD display = Input Password?
Press password and pess "Enter"
The master password is "0852".
If new password, 'Type again' will appeare and you need to press the new password
twice.
5. Adding new pager
LCD display = Add New Pager
Num > Cap code > Cnt
Num = 1st pager you want to program
Cap code = The cap code of the 1st pager you want to program.
Cnt = Total number of pagers you want to program.
After completion, press "select".
Page 4
6. Erasing Pager
LCD display = Erase Pager
Num > Cap code > Cnt
Num = 1st pager you want to erase
Cap code = It skips because the cap codes are already programmed.
After completion, press "select".
7. Setting Group Call
LCD display = Set Group Call no.
9111 > 0010000
Press group number you want to use and press "enter".
The group number has been changed now.
If possible not to change it because it may create confusion unless you use the same Tx
for very close two hospitals or churches.
8. Go to initial mode.
Press "cancel" any time and you can go to the initial mode any time.
Loading...