Nextar NCU101 User Manual
6
4
5
1
3
2
POWERMU
TECLKA.
P
-
+
SELDNUPSTLOCLOUDSCNMODEBANDTOP/RPTINTRD
M
REL
L
RPT2 INT
4
RDM
M
ODSCN
A.P
BND
CLK
MUSIC ALBUM ARTIST ESP45 FLASH
COMPACT
DIGITAL AUDIO
OPEN
SUB
SD
MMC
NCU101
E
S
VOL
M
U
1
TRACK
MUTE LOUD INT RDM RPT MP3
3
5 6
POP
ROCK CLASS
FLAT
W
C
O
L
T
S
U
O
L
DEAR CUSTOMER:
Selecting fine audio equipment such as the unit you have just purchased is only the start
of your musical enjoyment. Now it is time to consider how you can maximize the fun and
excitement your equipment offers.
We hope you get the most out of your equipment by playing it at a safe level.
One that lets the sound come through loud and clear without annoying blare or distortion,
and, more important, without affecting your sensitive hearing.
Sound can be misled. Over time your hearing " comfort level " adapts to higher volumes
of sound. So what sounds " normal " can actually be loud and harmful to your hearing.
Guard against this by setting your equipment at a safe level BEFORE your hearing adapts.
To establish a safe level:
Start your volume control at the lowest setting , then slowly increase the sound until you
can hear it comfortably and clearly, and without distortion we want you listening for a
lifetime.
Once you have established a comfortable sound level:
Set the dial and leave it there.
Taking a minute to do this now will help to prevent hearing damage or loss in the
future. After all, we want you listening for a lifetime.
ABOUT THIS MANUAL
This product features a number of sophisticated functions ensuring superior reception and
operation. All are designed for the easiest possible use, but many are not self-explanatory.
This operation manual is intended to help you benefit fully from their potential and to
maximize your listening enjoyment.
We recommend that you familiarize yourself with the functions and their operation by
reading through the manual before you begin using this product. In this operation manual,
the Basic Operation for each sound source is outlined at the beginning of its explanation,
covering simple operation for that source, such as merely playing music.
Remark:
In addition to normal audio CD, this unit can play CD-R and CD-R/W disc that contain
audio tracks as well; however, depending on the conditions of the recording equipment,
recording program or the CD-R as well as CD-R/W disc itself, some CD-R or CD-R/W
may not play.
When making music CD with CD-R or CD-R/W disc, too high recording speed may
result in poor signal quality and therefore, it is recommendable to select 24x or lower
speed for CD-R recording and 4x or lower speed for CD-R/W recording.
E 1
21
10
134 7
2 1114
15
20
4
RDM
MMC
M
ODSCN
A.P
BND
COMPACT
DIGITAL AUDIO
SUB
OPENSDMMC
LOCATION AND FUNCTION OF CONTROLS
16
1
19
3
17
8
18
REL
L
E
S
VOL
M
U
CLK
2
INT
1
TRACK
MUTE LOUD INT RDM RPT MP3
3
RPT
POP
ROCK
MUSIC ALBUM ARTIST ESP45 FLASH
5 6
CLASS FLAT
W
C
O
L
T
S
U
O
L
SD
12
5 6
9
1. SEL( AUDIO MODE SELECT)/ROTARY ENCODER
(1) Press SEL button shortly and repeatedly to change the mode in the sequence as
follows: --> VOL --> BAS --> TRE --> BAL --> FAD -->
1) VOLUME CONTROL
A. The volume level can be adjusted at any time by rotating the VOL knob as select
mode has been initially defaulted at volume mode.
B. The volume level is also obtained by stepping through the SEL button until the
function VOL is displayed and then rotate the VOL knob to adjust the sound level.
2) BASS CONTROL
A. Press the SEL button to select the bass mode until BAS appears on the display.
B. Rotate the VOL knob to adjust the bass effect.
3) TREBLE CONTROL
A. Press the SEL button to select the treble mode until TRE appears on the display.
B. Rotate the VOL knob to adjust the treble effect.
4) BALANCE CONTROL
A. Press the SEL button to select the balance mode until BAL appears on the display.
B. Rotate the VOL knob to increase or decrease the sound level of left / right speaker.
E 2
5) FADER CONTROL
A. Press the SEL button to select the fader mode until FAD appears on the display.
B. Rotate the VOL knob to increase or decrease the sound level of front / rear speaker.
(2) When pressed longer 2 seconds, it is activated as cyclical mode of following
functions for user’s selection.
-> BEEP (2nd/ALL/OFF) ->SEEK1/ 2 -> DSP(OFF/POP/ROCK/CLASSIC/FLAT)
->SUBW ON/OFF - > VOL LAST/VOL ADJ -> ESP 40/10 seconds mode.
After selecting the desired mode, rotate the VOL knob to select one setup item of
the desired mode.
BEEP 2ND, BEEP ALL, BEEP OFF MODE
The situation of beep sound is selected. The 3 mode is selected as also rotating the
VOL knob.
- Beep 2nd mode:
The beep is only generated when an allotted double key is pressed long (1 second).
- Beep all mode:
The beep is generated when every key is pressed.
- Beep off mode:
The beep sound is disabled when a key is pressed.
SEEK 1/SEEK 2 mode:( Only available during radio operation)
SEEK 1: Press and hold the >>| or |<< button to seek up or down for a station with a
strong signal. The seek stops when a station is reached .
SEEK 2: Press and hold the >>| or |<< button to seek up or down for a station with a
strong signal. The seek does not stop until the >>| or |<< button is released.
VOL LAST/VOL ADJ:
VOL LAST: The radio switches on at the actual volume it had when it was last
switched off.
VOL ADJ: Rotating the VOL knob you can pre-select a constant switch-on volume
after entering into this mode.
ESP 40 seconds/10 seconds:
In ESP mode, you can select 10 seconds or 40 seconds electronic shock protection
mode by rotating the VOL knob.
The default setting is at 40 seconds of anti-shock protection.
Using 10 seconds ESP will slightly improve the audio performance, while 40
seconds ESP will be effective when the vehicle is driven on a rough road.
2. COVER of MMC/SD and USB SOCKET
When needing to do MMC/SD or USB operation, open the cover, then insert the
MMC/SD card or USB bar into MMC/SD compartment or USB socket.
When no needing to do MMC/SD or USB operation, cover it with the cover after
pulling them out of the MMC/SD compartment or the USB socket.
E 3
Loading...