Nextar NCS102 User Manual
WIRING DIAGRAM
RCA LINE OUT
ANTENNA JACK
RED
R.
L.
WHITE
FRONT
SPEAKER
GREEN
+
L. R.
GREY
+
FRONT
SPEAKER
RED
3A
FUSE
B+ POWER
REAR
SPEAKER
L.
BLUE
+
+
REAR
R.
SPEAKER
WHITE
(BLACK) GROUND
4 SPEAKERS SYSTEM
NOTE:
Speakers with a load impedance less than 4 ohms could damage this device.
If you have 2 speaker system, make sure use a speaker with 4 ohm load impedance;
If you have 4 speaker system, make sure use a speaker with 8 ohm load impedance to reduce
the distortion during high volume level.
Power Supply Requirements...................DC 12Volts. Negative Ground
ON/VOL
TONE
EJECT
AM 540 620 750 900 1200 1600 KHz
CD IN
FM 88 91 94 98 103 108 KHz
BAND
ST
TUNE
BAL
ST
CAR STEREO WITH CASSETTE PLAYER
NCS102
LOCATION AND FUNCTION OF CONTROLS
1
ON/VOL
TONE
EJECT
11
AM 540 620 750 900 1200 1600 KHz
CD IN
FM 88 91 94 98 103 108 KHz
6
7
BAND
8. TONE BUTTON
4
5
Rotate the outer handle button to adjust the tone effect.
9. ST/ MO BUTTON
This operation is effective on FM reception only.
In RADIO mode, press this button to change between mono or stereo sound effect.
ST
TUNE
BAL
The ST LED indicator will light up indicating the status of stereo mode while there is
a strong signal from an FM station that is broadcasting in stereo. Mono improves the
reception of the distant stereo FM stations.
10. BALANCE CONTROL
ST
Rotate the outer handle to adjust the audio output balance of left and right speaker.
11. CD INPUT JACK
The car radio cassette player can be connected to a portable CD player through this
jack.
8 9
3
2
10
1. POWER ON/OFF AND VOLUME CONTROL
Rotate the VOL knob clockwise to turn the power ON; go on rotate to increase
the volume level. Rotate the VOL knob counter-clockwise to decrease the volume
level; go on rotate to turn the power off.
2. CASSETTE TAPE DOOR
In RADIO mode, insert a cassette into this slot, the tape playback starts automatically.
3. EJECT KEY
In TAPE mode, push this key halfway to fast forwards, and push it fully in to stop tape
playback and release cassette tape. The car radio cassette player will automatically go
into radio mode.
4. BAND SELECTOR BUTTON
Press the BAND button toggles AM / FM reception.
5. TUNING CONTROL
Rotate this control at radio mode to select your desired radio broadcasting station
within AM/FM.
6. ANALOGUE FREQUENCY DISPLAY
7. LED INDICATOR
INSTALLATION
DASH BOARD
METAL MOUNTING STRAP
HEX NUT
PLAIN WASHER
SPRING WASHER
TAPPING SCREW
CONSOLE
HEX NUT
PLAIN WASHER
HEX BOLT
Loading...