Nexersys CBTH 01 User Manual

CBTH-01

1. Ensure your mobile device has
Bluetooth 4.0 Low Energy or later
release

. Unwrap senso

4

r

7. Insert sensor in holder

2. Download the Cross Body Trainer
App on your Mobile Device

5. Insert

2 AAA Batteries

8. Close holder



Battery life indicator is found on app screen



usual Battery life = 6 months normal use

nexeys·

Manufacturer:Nexersys Corporation

3. Activate bluetooth on your
mobile device

6. Open flap on top of bag

9. Sync the app

a.) Open the bluetooth menu in the cross
body trainer app.
b.) Tap the bag to wake up the sensor.
c.) Click pair and you're ready to start
working out!

FCC Warning:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

o Reorient or relocate the receiving antenna.
o Increase the separation between the equipment and receiver.
o Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
o Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void
your authority to operate this equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.

The device has been evaluated to meet general RF exposure requirement. The device can be used in
portable exposure condition without restriction.