4. If odor continues, immediately call your gas supplier or your fire
department.
FOR YOUR SAFETY
1. Do not store or use gasoline or other flammable vapors and
liquids in the vicinity of this or any other appliance.
2. An LP cylinder not connected for use shall not be stored in the
vicinity of this or any other appliance.
MESSAGE TO OUR MEMBERS
Thank you for selecting The Grand Classic Grill.
Because this appliance contains features not found on any other grill, we recommend that you read this entire booklet
before you use your grill. Keep it in a handy place as it has answers to questions that may occur during future use.
Feel free to contact us if we can help you. When you write please include the model number of the grill.
We thank you for buying The Grand Classic Grill and wish you many years of enjoyment.
Note: This appliance is NOT intended to be installed in or on recreational vehicles or boats.
PLEASE RETAIN THIS MANUAL FOR FUTURE
TABLE OF CONTENTS
SECTION ONE: SECTION FIVE:
Precautions
Placement of the grill 3 Troubleshooting 15
SECTION TWO: SECTION SIX:
Assembly instructions Grill parts list
Installation of side shelf 4
Installation of left push bar
Installation of right push bar 6 Grilling hints 18
Installation of serving tray 7 Grill cooking chart 18
Rotisserie kit assembly
To match light the grill 8 SECTION EIGHT
Gas hook-up
Leak testing 9
Installer final checklist---- ----- ---10 SECTION NINE:
WARNING
Do not try lighting this appliance without
reading the “LIGHTING INSTRUCTIONS”
section of this manual.
TESTED IN ACCORDANCE WITH ANSI
Z21.58a-1995 STANDARD FOR OUTDOOR
COOKING GAS APPLIANCES. THIS
GRILL IS FOR OUTDOOR USE ONLY.
Check your local building codes for the proper
method of installation. In the absence of local
codes, this unit should be installed in accordance
with the National Fuel Gas Code No. Z223.11988 and the National Electrical Code
ANSI/NFPA No. 70-1990.
CALIFORNIA PROPOSITION 65WARNING
The burning of gas fuel generates some
byproducts, which are on the list of substances
which are known by the State of California to
cause cancer or reproductive harm. California
law requires businesses to warn customers of
potential exposure to such substances. To
minimize exposure to these substances, always
operate this unit according to the use and care
manual, ensuring you provide good ventilation
when cooking with gas.
SAFETY PRACTICES TO AVOID
PERSONAL INJURY
When properly cared for, your Kirkland Signature
Grill will give safe, reliable service for many years.
However, extreme care must be used since the grill
produces intense heat and that can increase accident
potential. When using this appliance basic safety
practices must be followed, including the following:
Read this Care and Use Manual carefully and
completely before using your grill to reduce the risk
of fire, burn hazard or other injury.
Do not repair or replace any part of the grill unless
specifically recommended in this manual. All other
service should be referred to a qualified technician.
CHILDREN SHOULD NOT BE LEFT ALONE OR
UNATTENDED IN AN AREA WHERE THE GRILL
IS BEING USED. NEVER ALLOW THEM TO SIT,
STAND OR PLAY ON OR AROUND THE GRILL AT
ANY TIME.
DO NOT STORE ITEMS OF INTEREST TO
CHILDREN AROUND OR BELOW THE GRILL OR
IN THE CART. NEVER ALLOW CHILDREN TO
CRAWL INSIDE OF THE CART.
Never let clothing, pot holders or other flammable
materials come in contact with or get too close to any
grate, burner or hot surface until it has cooled. Fabric
may ignite and result in personal injury.
For personal safety, wear proper apparel. Loose
fitting garments or sleeves should never be worn
while using this appliance. Some synthetic fabrics are
highly flammable and should not be worn while
cooking.
Only certain types of glass, heat-proof glass ceramic,
earthenware, or other glazed utensils are suitable for
grill use. Theses types of materials may break with
sudden temperature changes. Use only on low or
medium heat settings according to the manufacturer’s
directions.
Do not heat unopened food containers as a build-up
of pressure may cause the container to burst.
Use a covered hand when opening the grill lid. Never
lean over an open grill.
WHEN LIGHTING A BURNER, ALWAYS PAY
CLOSE ATTENTION TO WHAT YOU ARE DOING.
BE CERTAIN YOU ARE TURNING THE IGNITER
LABELED FOR THE BURNER YOU INTEND ON
USING.
DO NOT OPERATE BURNERS ON HIGH WITH
LID CLOSED.
2
PRECAUTIONS
When using the grill, do not touch the grill rack, burner
grate or immediate surroundings as these areas become
extremely hot and could cause burns. Use only dry
potholders. Moist or damp potholders on hot surfaces
may cause burns from steam. Do not use a towel or
bulky cloth in place or potholders. Do not let potholders
touch hot portions of the grill rack.
Grease is flammable. Let hot grease cool before
attempting to handle it. Avoid letting excess grease
deposits collect in the grease tray at the bottom of the
grill’s firebox. Clean often.
DO NOT USE ALUMINUM FOIL TO LINE THE GRILL
RACKS OR GRILL BOTTOM. This can severely upset
combustion air flow or trap excessive heat in the control
area.
For proper lighting and performance of the burners keep
the burner ports clean. It is necessary to clean them
periodically for optimum performance (see page 14). The
burners will only operate in one position and must be
mounted correctly for safe operation.
Clean the grill with caution. Avoid steam burns; do not
use a wet sponge or cloth to clean the grill while it is hot.
Some cleaners produce noxious fumes or can ignite if
applied to a hot surface.
INSECT WARNING!!! Spiders and insects can nest in
the burners of this and any other grill, and cause the
gas to flow improperly. This is a very dangerous
condition which can cause a fire to occur behind the
valve panel, thereby damaging the grill and making it
unsafe to operate. Inspect the grill twice a year.
Be sure all grill controls are turned off and the grill is
cool before using any type of aerosol cleaner on or
around the grill. The chemical that produces the spraying
action could, in the presence of heat, ignite or cause
metal parts to corrode.
Do not use the grill for cooking excessively fatty meats
or products which promote flare-ups. Do not operate the
grill under unprotected combustible construction. Use
only in well ventilated areas. Do not use in buildings,
garages, sheds, breezeways or other such enclosed areas.
THIS UNIT IS FOR OUTDOOR USE ONLY.
Keep the area surrounding the grill free from
combustible materials, trash, or combustible fluids and
vapors such as gasoline or charcoal lighter fluid. Do not
obstruct the flow of combustion and ventilation air. If the
unit is stored indoors ensure that it is cool. If propane is
used, the cylinder must be unhooked and the propane
cylinder stored outside in a well ventilated area, out of
the reach of children.
DO NOT USE BRIQUETTES OF ANY KIND IN THE
GRILL.
The Kirkland Signature Grill is designed for optimum
performance without the use of briquettes. Do not place
briquettes on the radiant as this will block off the area for
the grill burners to vent. Adding briquettes can damage
ignition components and knobs, and void the warranty.
Keep the back of the cart free and clear from debris.
Keep any electrical supply cord, or the rotisserie motor
cord away from the heated areas of the grill.
Never use the grill in extremely windy conditions. If
located in a consistently windy area (oceanfront,
mountaintop, etc.) a windbreak will be required (see
below). Always adhere to the specified clearance.
NEVER USE A DENTED OR RUSTY PROPANE TANK
PLACEMENT OF THE GRILL
CLEARANCE
To Non-Combustible Construction
A minimum of 3” clearance from the back of the grill to
non-combustible construction is required for the lid to
open fully.
DO NOT INSTALL THIS UNIT INTO COMBUSTIBLE
ENCLOSURES!
LOCATION
When determining a suitable location take into account
concerns such as exposure to wind, proximity to traffic
paths and keeping any gas supply lines as short as
possible. Locate the grill only in a well-ventilated area.
Never locate the grill in a building, garage, breezeway,
shed or other such enclosed areas without an approved
ventilation system. During heavy use, the grill will
produce a lot of smoke. Lock the wheels after the grill is
placed in a suitable position .
3
ASSEMBLY INSTRUCTIONS
INSTALLATION OF SIDE SHELF
The screws used to attach the side shelf are already screwed into the side panel (see the figure below). Remove the
screws from the side panel, align with the holes in the side shelf, and then re-screw into the holes on the side panel
of the grill.
4
INSTALLATION OF PUSH BAR
The screws used to attach the push bar are already screwed into the right side shelf. Remove the screws from the
right side shelf, align with the holes in the push bar, and then re-screw into the holes on the right shelf of the grill.
Press the cap against the ends of the push bar, and gently tap them into place.
Screw the Side door bar into the side holes as shown in the figure below.
5
INSTALLATION OF FLAME TAMER WITH CERAMIC BRIQUETTES
The screws used to attach each ceramic briquette are already screwed into the stainless steel flame tamers, remove the screws
and mounting brackets, from the flame tamer, align with the holes in the ceramic briquettes as shown in figure below and
re-tighten each screw.
Hang up the spice tray on the right door.
6
OTISSERIE KIT ASSEMBLY
The screws for rotisserie mount are already screwed into the rotisserie kit. Loose the screws
and install. Assemble the rotisserie skewer as shown in the figure below.
7
Loading...
+ 22 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.