Nex 720-0025, 720-0025 Owner's Manual

ASSEMBLY & OPERATING INSTRUCTIONS FOR OUTDOORS
STAINLESS STEEL GAS GRILL
FOR MODEL 720-0025 LP OUTDOOR GRILL
TABLE OF CONTENTS
SECTION TWO: SECTION SIX: Assembly Instructions ----------------4-9 Grill Parts List-------------------------------16-17
SECTION THREE: SECTION SEVEN: Gas Hook-UP & Leak Testing---------10 Grill Cooking Chart ----------------------18-20
Installer final checklist -----------------11 SECTION EIGHT: Operating Instructions -----------------12 Grill Recipe Suggestions -------------------21-23 Grill lighting Instruction Rotisserie ---------------------------------13 SECTION NINE: Warranty --------------------------------------24 SECTION FOUR: Using The Side Burner -----------------13
1
PRECAUTIONS
FOR YOUR SAFETY
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flames.
3. Open lid.
4. If odor continues, immediately call your gas
supplier.
WARNING Do not try lighting this appliance without reading the “LIGHTING INSTRUCTIONS” section of this manual.
FOR YOUR SAFETY Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
TESTED IN ACCORDANCE WITH ANSI Z21.58a-1995 STANDARD FOR OUTDOOR COOKING GAS APPLIANCES. THIS GRILL IS FOR OUTDOOR USE ONLY.
Check your local building codes for the proper method of installation. In the absence of local codes, this unit should be installed in accordance with the National Fuel Gas Code No. Z223.1­1988 and the National Electrical Code ANSI/NFPA No. 70-1990.
CALIFORNIA PROPOSITION 65­WARNING
The burning of gas fuel generates some byproducts, which are on the list of substances, which are known by the State of California to cause cancer or reproductive harm. California law requires businesses to warn customers of potential exposure to such substances. To minimize exposure to these substances, always operate this unit according to the use and care manual, ensuring you provide good ventilation when cooking with gas.
SAFETY PRACTICES TO AVOID PERSONAL INJURY
When properly cared for, your 720-0025 Grill will give safe, reliable service for many years. However, extreme care must be used since the grill produces
intense heat and can increase accident potential. When using this appliance basic safety practices must be followed, including the following:
Read this Care and Use Manual carefully and completely before using your grill to reduce the risk of fire, burn hazard or other injury.
Begin by ensuring proper assembly.
Do not repair or replace any part of the grill unless specifically recommended in this manual. All other service should be referred to a qualified technician.
CHILDREN SHOULD NOT BE LEFT ALONE OR UNATTENDED IN AN AREA WHERE THE GRILL IS BEING USED. NEVER ALLOW THEM TO SIT, STAND OR PLAY ON OR AROUND THE GRILL AT ANY TIME.
DO NOT STORE ITEMS OF INTEREST TO CHILDREN AROUND OR BELOW THE GRILL OR IN THE CART. NEVER ALLOW CHILDREN TO CRAWL INSIDE OF THE CART.
Never let clothing, pot holders or other flammable materials come in contact with or too close to any grate, burner or hot surface until it has cooled. Fabric may ignite and result in personal injury.
For personal safety, wear proper apparel. Loose fitting garments or sleeves should never be worn while using this appliance. Some synthetic fabrics are highly flammable and should not be worn while cooking.
Only certain types of glass, heatproof glass ceramic, earthenware, or other glazed utensils are suitable for grill use. Theses types of materials may break with sudden temperature changes. Use only on low or medium heat settings according to the manufacturer’s directions.
Do not heat unopened food containers as a build-up of pressure may cause the container to burst.
Use a covered hand when opening the grill lid. Never lean over an open grill.
WHEN LIGHTING A BURNER, ALWAYS PAY CLOSE ATTENTION TO WHAT YOU ARE DOING. BE CERTAIN YOU ARE TURNING THE IGNITER LABELED FOR THE BURNER YOU INTEND ON USING.
2
PRECAUTIONS
When using the grill, do not touch the grill rack, burner grate or immediate surrounding area as these areas become extremely hot and could cause burns. Use only dry potholders. Moist or damp potholders on hot surfaces may cause burns from steam. Do not use a towel or bulky cloth in place or potholders. Do not let potholders touch hot portions of the grill rack.
Grease is flammable. Let hot grease cool before attempting to handle it. Avoid letting grease deposits collect in the bottom of the grill. Clean often.
DO NOT USE ALUMINUM FOIL TO LINE THE GRILL RACKS OR GRILL BOTTOM. This can severely upset
combustion airflow or trap excessive heat in the control area. The result of this can be melted knobs, rotary igniters and increased chance of personal injury.
For proper lighting and performance of the burn ers keep the ports clean. It is necessary to clean them periodically for optimum performance. The burners will only operate in one position and must be mounted correctly for safe operation.
Clean the grill with caution. Avoid steam burns; do not use a wet sponge or cloth to clean the grill while it is hot. Some cleaners produce noxious fumes or can ignite if applied to a hot surface.
INSECT WARNING!!! Spiders and insects can nest in the burners of this and any other grill, and cause the gas to flow from the front of the burner. This is a very dangerous condition, which can cause a fire to occur behind the value panel, thereby damaging the grill and making it unsafe to operate. Inspect the grill twice a year.
Be sure all grill controls are turned off and the grill is cool before using any type of aerosol cleaner on or
around the grill. The chemical that produces the spraying action could, in the presence of heat, ignite or cause metal parts to corrode.
Do not use the grill for cooking excessively fatty meats or products, which promote flare-ups. Do not operate the grill under unprotected combustible construction. Use only in well ventilated areas. Do not use in buildings, garages, sheds, breezeways or other such enclosed areas.
THIS UNIT IS FOR OUTDOOR USE ONLY.
Keep the area surrounding the grill free from combustible materials, trash, or combustible fluids and vapors such as gasoline or charcoal lighter fluid. Do not obstruct the flow of combustion and ventilation air. If the unit is stored indoors ensure that it is cool. If propane is used, the cylinder must be unhooked and the propane cylinder stored outside in a well-ventilated area, out of reach of children.
DO NOT USE BRIQUETTES OF ANY KIND IN THE GRILL.
The stainless steel gas grill is designed for optimum performance without the use of briquettes. Do not place briquettes on the radiant as this will block off the area for the grill burners to vent. Adding briquettes can damage ignition components and knobs, and void the warranty. Keep the back of the cart free and clear from debris. Keep any electrical supply cord, or the rotisserie motor cord away from the heated areas of the grill.
Never use the grill in windy conditions. If located in a consistently windy area (oceanfront, mountaintop, etc.) a windbreak will be required. Always adhere to the specified clearance.
NEVER USE A DENTED OR RUSTY PROPAN TANK
PLACEMENT OF THE GRILL
CLEARANCE To Non-Combustible Construction
A minimum of 3” clearance from the back of the grill to non-combustible construction is required for the lid to open fully.
DO NOT INSTALL THIS UNIT INTO COMBUSTIBLE ENCLOSURES!
LOCATION
When determining a suitable location take into account concerns such as exposure to wind, proximity to traffic paths and keeping any gas supply lines as short as possible. Locate the grill only in a well-ventilated area. Never locate the grill in a building, garage, breezeway, shed or other such enclosed areas without an approved ventilation system. During heavy use, the grill will produce a lot of smoke. Lock the wheels after the grill is placed in a suitable position according to the sticker located beneath the right door.
3
Assembly Instructions
PLEASE READ THE INSTRUCTIONS CAREFULLY AND FOLLOW STEP BY STEP.
TOOLS REQUIRED:
Step 1:
Assemble casters to bottom panel with ¼”-20x3/4” screws. Casters with brakes should be assembled on the mark “L” side of bottom panel.
“L”
Step 2:
Assemble bottom panel to side panels with 5/32”-32x1/2” screws.
4
Step 3:
Align the holes on the mark “rear panel - b” to the bottom panel. Then, assemble it with 5/32”-32x1/2” screws. Align the holes on the mark “rear panel - a” to the mark “rear panel - b”. Then, assemble it with 5/32”-32x1/2” screws.
Finished Step 3:
“rear panel – a”
“rear panel - b”
Step 4:
Align the door holes to the side panels as picture shown. Assemble it with ¼”-20”x1/2” screws.
5
Step 5:
Assemble the door handles with 5/32”-32x1/4” screws as picture shown below.
Step 6:
Remove the upper portion of grill from carton. Insert the upper portion of the grill onto the cart from the top.
Insert from the top
6
Step 7:
Assemble side burner with ¼”-20x1/2” screws. Align the holes on the right side of grill housing and screw through the holes in the right side. Tighten into the grill housing as per the diagram below. Then tighten the gas hose to side burner valve. Repeat this step for the left side shelf.
Step 8:
Assemble push bar with ¼”-20x1/2” screws to the left side shelf.
7
Loading...
+ 18 hidden pages