NewHank Control User Manual

Page 1
QUALITY AV PRODUCTS
User Guide
and Reference Manual
Page 2
QUA LIT Y AV PROD UCTS
CONGRATULATIONS AND THANK YOU FOR PURCHASING
THE NEWHANK CONTROL USB
Please carefully read and understand the instructions in this manual thoroughly before attempting to operate this unit. These instructions contain important safety information regarding the use and mainten­ance of this unit. Take special care to follow all warning symbols and labels both on the unit and printed in this manual. Also, Please keep this manual with the unit, for future reference.
IMPORTANT SAFETY PRECAUTIONS
CAUTION:
WITH AN EXTENSION CORD, RECEPTACLE, OR OTHER TYPE OF ELECTRICAL OUTLET UNLESS THE WIDE BLADES CAN BE CAREFULLY INSERTED INTO A MAT­CHING WIDE SLOT.
ATTENTION:
TE FICHE POLARISEE AVEC UN PROLONGATEUR, UNE PRISE DE COURANTOU UN
-E AUTRE SORTIE DE COURANT, SAUF SI LES LAMES PEUVENT ETRE INSEREES A FOND SANS EN LAISSER AUCUNE PARTIE A DECOUVERT.
TO PREVENT ELECTRIC SHOCK DO NOT USE THIS (POLARIZED) PLUG
POUR PREVENIR LES CHOCS ELECTRIQUES NE PAS UTILISER CET-
SET-UP PRECAUTIONS
Please be sure to make any connections before plugging the media player in to an electrical outlet. All fader and volume controls should be set to zero or minimum position, before the SD player is switched on. If the media player has been exposed to drastic temperature fuctuation (e.g. after transportation), do not switch on the media player immediately. The arising condensation of water might damage your device. Leave the device switched off until it has reached room temperature.
Operating Determinations:
When installing this media player, please make sure that the device is not exposed or will not be exposed to extreme heat, moisture or dust! Do not operate the media player in extremely hot (more than 40°C /104°F ) or extremely cold (less than 5°C/40°F) surr oundings. Keep the unit out of direct sunlight and away from heaters.
MAIN FEATURES
• One USB 2.0 Port and One SD Card Sl ot
• Aux input
• Microp hone Input with Volume Control
• Aux/Mp3 L evel ControlVolume
• Line Lev el ControlVolume
• Bright Digital Screen
NEWHA NK - www. newha nk.co m - CO NTROL USB Ins truct io n Manua l Page 2
• Mp3 Cont rol Player
• Set Up Different Effect EQ
• Master Vo lume Control
Treble ControlMaster
Bass Cont rolMaster
• Select able Single or Continuous Play
Page 3
GENERAL FUNCTIONS AND CONTROLS
Figure 1
QUA LIT Y AV PROD UCTS
1 2 3 5 6 7 8 9 10 11 12 13
4
16
20 19 18 17
15
14
Figure 2
A. MEDIA PLAYER (FIGURE 1)
1. POWER SWITCH - This is the main power ON/OFF switch.
2. MICROPHONE - / -
.
plug The volume output level for this microphone will be controlled by its own respective MICLEVEL
VOLUME KNOB(10) .KNOB(8) OR Note We recommend that you use a 500 600ohm microphone
for the best soundquality
This combo jack will accept a standard 1 4 plug or XLR 3 pin balanced male
: -
.
3. AUX INPUT JACK - This stereo Aux input is for the use of a Mp3 player, or other line source.
4. LCD DISPLAY - This high quality LCD display indicates all the functions, as they are occurring.
5. USB/SD BUTTON - Press this button to toggle between the USB port or SD Card slot.
6. SD CARD SLOT - This is where you load your SD card.
7. USB PORT - This is the USB port where you can insert a USB stick, USB card reader, or compatible
external hard drive for playback.
8. MICLEVEL CONTROL - This knob is to control the m level.icrophone
9. AUX/MP3 LEVEL -- This knob is to control the evel.mp3 l
10. LINE LEVEL CONTROL - This knob is used to control the input evel.line l
11. MASTER VOLUME CONTROL - This knob is used to control the master output level. To avoid
speaker damage that may be caused by excessive volume, be sure this knob is always set to the lowest level before turning the unit on.
12.CHANNEL TREBLE CONTROL - This knob is used to adjust the treble level of a channel allowing for a maximum treble gain of +15dB or maximum decrease of -15dB. Turning the knob in a counter-clockwise direction will decrease the amount of treble applied to a channel signal, turning the knob in a clockwise direction will increase the amount of treble applied to a channel signal.
13.CHANNEL BASS CONTROL - This knob is used to adjust the low frequency levels of a channel allowing for a maximum bass gain of +15dB or maximum signal decrease of -15dB. Turning the knob in a counter-clockwise direction will decrease the amount of bass applied to a channel signal, turning the knob in a clockwise direction will increase the amount of bass applied to a channel signal.
14. EQ BUTTON - Press this button can transform different sound effect.CONTROL
15. STOP/PLAY/PREVIOUS TRACK/NEXT TRACK
NEWHA NK - www. newha nk.co m - CO NTROL USB Ins truct io n Manua l Page 3
Page 4
QUA LIT Y AV PROD UCTS
STOP - Press this button to stop the current track. PLAY - Press this button to start the track .
PREVIOUS TRACK - Press this button to go back to the previous track.
NEXT TRACK -
16. REPEAT BUTTON -Press this button to repeat the track.
Press this button to go to next track.
B. MEDIA OPERATOR - REAR (FIGURE 2)
17. AC CONNECTION - This connector is used to supply main power to the unit via the included
detachable power cord The power connection uses an I E C type connector use only the supplied polarized AC power cord Use only a power cord that matches this type of connection Be sure to only connect this unit to a power outlet that matches the printed power label on the unit Never use a power cord when the ground prong has been removed or broken off The ground prong is used to reduce the risk of electrical shock in case of an electrical short. This cord is designed to fit in one direction only. Do not attempt to force a cord if it does not fit, be sure the cord is being inserted
18. BALANCED XLR MASTER OUTPUTS JACKS - The Master Output includes a pair of XLR Balanced jacks as well as a pair of . The 3-pin XLR jacks send a balanced output signal. These jacks should be used when you will be driving an amp or other audio equipment with a balanced input, or whenever you will be running a signal line greater than 15 feet.
Always, use these jacks whenever possible.
19. AUDIO OUT R & L - The Master Output includes a pair as well as a pair of RCA Unbalanced Jacks. The RCA jacks send a unbalanced output signal. Use these jacks
to send standard audio to a mixer or receiver. The red colored jack represents the right channel o-
utput and white jack represents the left channels output.
20. LINE INPUT JACKS - CD players, Tape Decks and other line level instruments may be connected to these jacks. The red colored RCA jack represents the right channel input
and the white represents the left channel input.Input volume will be controlled by channel
one fader.
. . . . , ,
. .
.
.
properly
RCA Unba lanced Jacks (18)
XLR Balanced Jacks (17)
.
SPECIFICATIONS
GENERAL Model: NEWHANK CONTROL USB, USB/SD Mp3 CONTROL PLAYER.
Type: SD Card and USB MP3 CONTROL PLAYER . Installation: Place on flat surface or mount in flat 19RACK
Power supply:
Power consumption: 4.5W Environmental conditions: Operational temperature: 5 to 35 C (41 to 95 F)˚ ˚
Accessories: Connecting RCA Cables
Please Note: All specifcations and improvements to and in the design of this unit and this manual are subject to change at any time without any prior written or published notice.
Single Voltage:
AC 220V, 50Hz
Operational humidity: 25 to 85% RH (no condensation) Storage temperature: -10 to 60 C (14 to 140 F)˚ ˚
Mains power lead
QUALITY AV PRODUCTS
www.newhank.com
NEWHA NK - www. newha nk.co m - CO NTROL USB Ins truct io n Manua l Page 4
Loading...