Newer Technology GripStand Station Service Manual
GripStand™ Station
Dock Cable Replacement
Should one of the eight 30-pin dock connectors inside the GripStand Station become damaged or non-functional,
discontinue using that charging slot until you have replaced the malfunctioning cable to avoid damaging an iPad!
The GripStand Station uses a custom shaped 30-Pin USB to Dock cable - replacement of the cable with any model
other than the approved Newer Technology 30-Pin USB to Dock cable will not work and will cause damage to the
GripStand Station.
The GripStand Station comes equipped with 72” USB to Dock cables from the factory and needs to be replaced with
the same. One extra replacement cable is included with the GripStand Station.
For extra replacement cables, please visit: http://www.newertech.com/gripstandstation
➀ ➁
To remove a 30-pin dock cable, turn the GripStand Station so that you can see the rear and the dock cable channels.
Determine which cable you want to remove (in this scenario, the second cable from the bottom will be replaced).
Unscrew the four Phillips screws that secure the clear plastic cable cover (circled in red in step ➁), and remove the
plastic cover.
➂
Once the plastic cover is removed, locate the dock cable that you wish to remove. From the bottom of the
GripStand Station, lift up on the cable and remove it from the wire channel to release it.
➃
⑤ ⑥
Using a retractable pen (a at tool that you can push with, and not cut the cable is all that’s required), gently push
on each side of the dock connector to release it from the dock cable slot. Once you press it out of the slot, the pen
will slide into the GripStand Station housing.
⑦
Once you have released the dock cable from the GripStand
Station, remove it from the black wire loom that is used for
cable managment. Then, slide the cable out from the inside
and remove it completely.
Take your replacement cable and feed it back through the
hole that you removed the cable from.
⑧ ⑨ ⑩
⑪
Make certain that the iPad is laying at in the GripStand Station side guide rails and then rmly push in on the iPad,
pressing the dock cable into the back wall of the GripStand Station. This seats the dock cable perfectly at and
straight into the retaining slot for the dock connector. Reinstall the cable into the guide channel and replace the
plastic cable cover and the replace the black wire loom around the USB cables to complete the installation.
Insert the new 30-pin dock cable into the iPad. Remember, the iPad is upside down so the Newer Technology logo on the dock cable will be facing
away from you when you plug it in.
Slide the iPad into the slot where the cable has been removed from. Gently
feed the cable into the hole in the back of the GripStand Station, being very
careful to not pull on the cable too much; you do not want to disconnect it
from the iPad. Feed the cable all the way back through the hole. When you
feel resistance, meaning the dock cable is against the back wall, STOP.
R2 12/20/11 JD
Copyright ®2011-12 Newer Technology Inc. All Rights Reserved.
NWTMANGSSCBL
Loading...