New England Arbors VA20200 User Manual

ASSEMBLY INSTRUCTIONS

The Solar Light Keystone

 

    

     

www.edenarbors.com

 

Please read through before starting assembly.

Check Box for These Contents

In the event of missing or defective parts please call our customer service dept. at

1. Solar Keystone Top Lid (1)

2. Battery Pack (1)

3. Solar Keystone Body (with Lens) (1)

4. 5/8” Stainless Steel Screws (2)

Tools You Will Need

• Phillips-head Screwdriver

• Flat-head Screwdriver

• Stool or Short Ladder

General Information

• Read Instructions through carefully before beginning
assembly.

• You should not need to use excessive force when assembling
components.

• The Solar Light Keystone is designed to retroactively fit over
your current arbor such as the Livingston Arbor, Vienna Arbor,
Florence Arbor, Monaco Arbor, Frederickton Arbor, and Stockport
Arbor, as well as the Vienna Trellis.

• If this solar keystone is to be installed on a new arbor, do not attach
the keystone lid during assembly as per step 3 on the next page.

4

1

2

3

1 800 282 9346, ext #20 (Mon. to Fri. 8:00 AM to 4:00 PM EST).

MARCH 2012

1

STEP S

1

Remove the two screws holding the solar keystone lid to the body

using a phillips head screwdriver and retain them to be used again

later on.

2

Connect the battery pack on the underside of the solar keystone lid

as shown.

3

Remove the existing keystone lid (only) on the desired keystone.

Use a flat-head screw driver to gently pry the lid off the keystone

body as shown.

4

Align and slide the solar light keystone lid and body to the existing

keystone as shown. The new keystone lid should lock into place.

5

1

www.edenarbors.com

2

Support the keystone body while fastening the two screws removed

in step 1.

3

5

Note: if this is a new arbor installation,

don’t install the keystone top lid and

proceed to step 4

4

2

The Solar Light Keystone Arbor