NewAir G70 User Manual

Page 1
Owner’s Manual
Model G70
IMPORTANT SAFETY INFORMATION: Always read this manual rst
before attempting to install or use this heater. For your safety, always comply with all warnings and safety instructions contained in this manual to prevent personal injury or property damage.
7211460100R00
Page 2
Table of Contents
Welcome & Congratulations ................3
IMPORTANT INSTRUCTIONS . . . . . . . . . . . . . . .4
Heater Installation ........................7
Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9
Maintenance and Cleaning . . . . . . . . . . . . . . . .10
Warranty ...............................10
Always use a qualied technician
or service agency to repair this heater.
!
NOTE: Procedures and techniques that are considered important enough to emphasize.
CAUTION: Procedures and techniques which, if not carefully followed, will result in damage to the equipment.
WARNING: Procedures
and techniques which, if not carefully followed, will expose
the user to the risk of re,
serious injury, or death.
Page 3
Welcome & Congratulations
Thank you and congratulations for choosing to purchase an electric heater from New Air, the world leader in electric heaters.
Please carefully read and save these instructions.
CAUTION: Read all instructions and warnings carefully before
starting installation. Failure to follow these instructions may result
in a possible electric shock, re hazard and will void the warranty.
Please record your model and serial numbers below for future reference: model and serial numbers can be found on the Model and Serial Number Label of your heater.
NO NEED TO RETURN TO THE STORE
Questions with operation or assembly? Require Parts Information?
Product Under Manufacturer’s Warranty?
Contact us Toll-Free 1-800-734-0405
Monday to Friday 7:30 a.m. to 5:00 p.m. PST
Please have your model number and product serial number ready.
Page 4
IMPORTANT INSTRUCTIONS
Read all instructions before
using this appliance.
The heater is hot when in use.
To avoid burns, do not let bare skin touch hot surfaces. The trim around the heater outlet becomes hot during heater operation. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9m) from the front of the unit.
Extreme caution is necessary
when any heater is used by or near children or invalids and whenever the unit is left operating and unattended.
Always unplug the heater
when not in use.
Do not operate any unit with
a damaged cord or plug, or if the heater has malfunctioned, or if the heater has been dropped or damaged in any manner. Return heater to authorized service facility for examination, electrical or mechanical adjustment or repair.
Do not use outdoors. The heater is not intended for
use in bathrooms, laundry areas and similar indoor locations. Never locate heater where it may fall into a bathtub or other water container.
Do not run the cord under
carpeting. Do not cover cord with throw rugs, runners or the like.
Arrange cord away from trafc
area and where it will not be tripped over.
To disconnect the unit, turn
the controls off, then remove the plug from the outlet.
Connect to properly grounded
outlets only. Do not insert or allow foreign
objects to enter any ventilation or exhaust opening as this may
cause an electric shock or re, or
damage to the heater.
To prevent a possible re, do
not block air intake or exhaust in any manner. Do not use on
Page 5
IMPORTANT INSTRUCTIONS
soft surfaces, like a bed, where openings may become blocked.
All electrical heaters have hot
and arching or sparking parts inside. Do not use in areas where gasoline, paint, or ammable liquids are used or stored or where the unit will be exposed to ammable vapours.
Do not modify the heater.
Use it only as described in this manual. Any other use not recommended by the
manufacturer may cause re,
electric shock or injury to persons.
This heater is not intended for
use with an extension cord. Plug cord directly into appropriate wall receptacle.
This heater includes a visual
alarm (red light) to warn that parts of the heater are over heating. If
the red light rurns on, immediately turn heater off and inspect for any objects on or adjacent to the heater that may cause high temperatures. DO NOT OPERATE WHEN RED LIGHT IS ON.
Always use a certied
electrician should new circuits or outlets be required.
Disconnect all power supply
before performing any cleaning, maintenance or relocation of the unit.
When transporting or storing
the unit and cord, keep in a dry place, free from excessive vibration and store so as to avoid damage.
SAVE THESE INSTRUCTIONS
Page 6
IMPORTANT SAFETY INSTRUCTIONS
Grounding Instructions
This heater is for use on 240 Volts. The cord has a plug as shown on Figure 1. No adapter should be used with this unit. The type outlet is a 240 Volt grounding outlet. When properly installed, it provides a ground connection through the cord to the heater to protect the operation from electric shock.
Figure 1:
Plug and outlet
conguration for 240
Volt, 20 Amp circuit
Ground
Plug
Outlet
Page 7
Heater Installation
HEATER LOCATION AND CLEARANCES
The heater is intended for use
located on a hard oor, table top,
desk or on shelf, and the like, or suspended on a wall or ceiling by means of provided hanger bracket.
When suspended from wall or ceiling heater should be located along outside walls to provide perimeter air circulation.
The discharge air should wipe the walls without blowing directly on them. (Figure 2)
If heater is to be tilted on horizontal axis after mounting ­ensure a minimum clearance of
26.5 inches (67 cm) between oor
and bottom of heater. Also, when mounted to ceiling, ensure a minimum clearance of 3.5 inches (9 cm) from ceiling to top of heater. Ensure the air discharge is parallel to or away from walls.
INSTALLATION WITH WALL/ CEILING HANGER BRACKET
!
NOTE: To prevent personal
injury always use a licensed electrician to install new outlets or circuits.
Figure 2
OUTSIDE WALL
DISCHARGE
The use of the hanger bracket allows the unit to be rotated approx 45 degrees in each direction from centre, when attached to wall and tilted in 45 degrees range while suspended from a wall or ceiling.
!
NOTE: The hardware for
mounting the hanger bracket to the wall or ceiling is not included.
CAUTION: When turning
and/or tilting the heater do not block the exhaust opening.
The following steps are shown in Figure 3.
Locate a stud or other 1. suitable support and install hanger bracket on wall or ceiling. Select location so control knob on back of heater will be reached easily.
Page 8
Heater Installation
Insert carriage bolt into 2. square opening of heater handle.
Slide spacer over the carriage 3. bolt shaft and insert in hanger bracket opening and hold them in position.
Slide lock washer and thread 4. on T-Handle onto carriage bolt, turn to tighten.
Hanger Bracket Mounting Options
Figure 3
Hanger bracket
T-Handle
Lock washer
Spacer
Carrage Bolt
Air in
Air out
Page 9
Operation
Setting the Thermostat
Before connecting or 1.
disconnecting plug, turn knob fully counterclockwise. (Figure 4)
2. Heater is equipped with a thermostat. To adjust temperature to your individual requirements, turn thermostat control knob clockwise all the way to turn heater on, the yellow power light will illuminate (Figure 5). When room reaches desired temperature, turn thermostat knob counterclockwise until you hear click. Leave in this position to maintain room temperature at this setting. For additional heat, turn clockwise until you hear click again and heater will turn on. To shut heater off turn thermostat knob counterclockwise all the way. The yellow power indicator light will turn off.
!
NOTE: Heater is equipped
with a fan delay to dissipate residual heat from the element. Heater fan will run for a brief period after heater has reached room temperature.
Figure 4
Thermostat control knob (shown in off position)
Figure 5
Yellow light
Red light
Page 10
Maintenance and Cleaning
WARNING: Disconnect
power before attempting any maintenance or cleaning to
reduce the risk of re, electric
shock or damage to persons.
CAUTION: Allow at least
30 minutes for the heater to cool before attempting any
Warranty
NewAir Electric Heaters are tested and inspected prior to shipment and are guaranteed free from defect to the purchaser of each new product. Any part which proves to be defective in material or workmanship under normal use within one year will be repaired or replaced without charge. The Company will not be responsible for any expense incurred for installation, removal from service, or transportation costs. Any such defect should be brought to the attention of the Dealer where the product was purchased and is authorized to repair or replace within the terms of this warranty.
The Company’s only obligation under this warranty will be at its sole option to repair or replace any part proving defective or to refund the purchase price thereof.
maintenance or cleaning.
To clean the exterior surface, use a solution of water and mild detergent, apply with damp sponge. Wipe dry with a dry cloth. DO NOT plug heater into outlet until it has dried thoroughly.
The owner/user assumes all other risks, if any, including the risk of any direct, indirect or consequential loss or damage arising out of the use of or inability to use the product.
The warranty will not apply if, in the sole judgment of the Company, damage or failure has resulted from accident, alteration, misuse, abuse, incorrect installation, or operation on an incorrect power source.
The foregoing is in lieu of all other warranties expressed, implied, or statutory, and the Company neither assumes, nor authorizes any person to assume for it any other obligation, or liability in connection with said product.
NewAir
1100 S. Linwood Ave. Building B Santa Ana CA 92705 USA
Toll Free: (800) 734-0405
© 2011 NewAir
10
Loading...