R
HAN DLI NG IN STR UCT ION
opticalCON
A. HANDLING INSTRUCTION
3
|
N O2-4 FDW-A S olde ring Instruction
Cable Preparation
A
Strip all 4 copper cords at a length of
3 mm, while using the baring tool.
Slide the prepared shrink tube with a length
B
of 10 mm over copper cord (pin 1 and 4).
Pre-solder tip of the copper cords for
C
enhanced heat transfer.
ATTENTION! Don’t use too much solder.
Page 1
opticalCON - Handling Instruction NO2-4FDW-A
I
Cable Soldering
Cable Shrinking
Insert pre tinned copper cords into the
D
terminals and solder them on.
Attention: Do not use too much solder.
Avoid cold solder joints!
Slide heat shrink over solder joint and shrink
E
it with a hot air gun.
Page 2
HOT AIR
GUN
B. Finished Product
Solder cups completely
covered with heat shrink.
Attention: Set appropriate temperature
according used wires and shrink tube.
NEUTRIK AG LI T: +423 / 237 24 2 4 F: +423 / 232 53 93
NEUTRIK USA Inc. USA T: +1 704 / 972 3050 F: +1 704 / 438 9202
NEUTRIK UK Ltd. UK T: +44 1983 / 811 441 F: +44 1983 / 811 439
NEUTRIK Vertrie bs GmbH DE / NL / AT/DK T: +49 8131 / 280 890 F: +49 8131 / 280 830
Draft. Nr.: BDA 360 / 3102M2141 Upda te: 03.02.2014
( )
I I
Data subject t o change without prior n otice. 2014 NEUTRIK . ALL RIGHTS RESERVED. NEUTRIK are re gistered trademark.
www.neutri k.comwww.neutri k.com
No “cold” solder joints.
NEUTRIK France FR T: +33 1 / 4131 6750 F: +33 1 / 4131 0511
NEUTRIK Tokyo Ltd. JP T: +81 3 / 3663 4733 F: +81 3 / 3663 4796
NEUTRIK Hong Kong Ltd. HK T: +852 / 2687 6055 F: +852 / 2687 6052
©
® ®
R
Loading...