NEUTRIK NC3FX-TOP, NC5FX-TOP, NC3MX-TOP, NC5MX-TOP Assembly Manual
R
ASSEMBLY INSTRUCTION
NC3FX-TOP & NC5FX-TOP
P
MOUNTING VERSIONS
1 3& STANDARD ASSEMBLY OF XLR CONNECTOR
23& WITH ASSESSORIES:
1 STANDARD CABLE ASSEMBLY
IP65 RATED AND UL50E APPROVED.
CABLE & BOOT ASSEMBLY WITH INSERTION TOOL.
ITX-TOP: Cable insertion tool to guide the cable into the boot.
45°~45°
~
A
XLR Cable Connector
|
Cut cable end approx.45°.
2 CABLE & BOOT ASSEMBLY WITH INSERTION TOOL
A
B
B
Slide the bushing over the cable.
To ease the boot assembly apply some
cable pulling lubricant to the cable ends.
A
Position Insertion Tool ontothe the
cable.
Wet the tip with mounting fluid.
B
Page 1BDA 549 V2
XLR TOP NC3FX-TOP
I
C
D
3 ASSEMBLY INSERT AND CONNECTOR
Cable O.D. - 8.0 mm: 5.0
Cable O.D. - 8.0 mm: 5.0
A
[0.19 - 0.32”]
[0.19 - 0.32”]
18 [0.71”]
4 [0.16”]
Slide the cable with the tool throught the
C
boot.
Remove the tool.
D
A
Prepare cable asshown.
Insert wires into the terminals and SOLDER
B
them.
B
SOLDER
C
D
Wiring 3 pole 5 pole:
G
1
1
Put chuck ontothecable.
C
Attention: Pay attention to the guiding key.
Slide insert and chuck together into the
D
housing.
Important:
Align the insertbypositioningas shown.
2
2
3
G
5
4
3
Page 2BDA 549 V2
Loading...